624619
9
Verklein
Vergroot
Pagina terug
1/17
Pagina verder
18. 19.
Your rear brake and shifter housing will run parallel around the left side of the head tube. From there you
will run those two into the housing ports on the non drive side of the head tube. The Rear shift housing and
brake housing exit the front triangle just above the Innity Link. The brake exiting on the non drive side, the
shift exiting on the drive side, both continuing into the coorispoding port on the swing arm.
*Use rubbiung alcohol to lubricate the housing. It will pass through the rubber grommets much easier.
*It may be easier in some cases to run the housing from the back of the bike up.
Caution: The failure to properly route shifter housing can cause malfunction of the shift mechanism and
unexpected shifting of gears.
The rear brake housing will exit the swing arm
via the port on the chainstay and go from there
directly to the brake caliper. If possible, adjust
the housing/caliper angle to give the housing the
cleanest, shortest route to the port.
CABLE HOUSING SETUP
The SB6c uses internally routed full length cable housing. By using full cable housing, we
have eliminated break points in the line of your shifter housing. This allows riders to experience
better overall shifting performance by reducing the entrance of unwanted elements such as
sweat and sediment. By routing that housing internally we add to the protection form the
elements and clean up the lines of the bike. No more zip ties to snag your shorts on and no
more loose housing rattling around on your paint.
Do not remove any of the housing guide tubes that are installed in your frame and swingarm.
They will be used to pull your housing through the frame. If you are replacing housing, use the
old housing to pull your new housing through the frame.
If you don’t have the tubes or old housig as a guide you can sh for it, but it will be easier to
get an internal routing tool.
REAR BRAKE AND DERAILLEUR ROUTING.
REAR BRAKE CONTINUED
REAR DERAILLEUR CONTINUED
The rear shift housing exits the swing arm on
the top, just above the derailleur. Make sure
you leave enough slack in the housing to allow
for a smooth curve from the housing port to the
derailleur.
DROPPER POST
The dropper post housing will exit teh frame at
the upper port on the drive side of the head tube.
It is best to run the housing from the seatpost up
using either the guide provided with a new frame
or the previous housing. Without a guide, it can
be difcult to sh the housing into the downtube,
but it is possible.
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yeti Cycles SB6C bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yeti Cycles SB6C in de taal/talen: Engels als bijlage per email.

De handleiding is 5,79 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info