689860
315
Verklein
Vergroot
Pagina terug
1/363
Pagina verder
8A-12
Chapter 8 Part A Electrical system (XV535 models)
19.5 Sidestand switch mounting screws 20.4 Insert a pointed tool into the hole
(arrow), compress the prong and pull out
the clutch switch
21.1 Disconnect the horn wires (A) and
remove the bracket bolt (B)"
3 With the sidestand in the down position, the meter should
indicate infinite resistance.
4 If the switch fails either of these tests, replace it.
Replacement
Refer to illustration 19.5
5 With the sidestand in the up position, unscrew the two screws
and remove the switch (see illustration). Disconnect the switch
electrical connector.
6 Installation is the reverse of the removal procedure.
20 Clutch switch - check and replacement
Check
1 Disconnect the electrical connector from the clutch switch.
2 Connect an ohmmeter between the terminals in the clutch switch.
With the clutch lever pulled in, the ohmmeter should show continuity
(little or no resistance). With the lever out, the ohmmeter should show
infinite resistance.
3 If the switch doesn't check out as described, leplace it.
Replacement
Refer to illustration 20.4
4 If you haven't already done so. disconnect the wiring connector.
Insert a pointed tool into the mounting hole, compress the prong and
pull the switch out (see illustration).
5 Installation is the reverse of removal.
21 Horn - check and replacement
Check
Refer to illustration 21.1
1 Disconnect the electrical connectors from the horn (see
illustration). Using two jumper wires, apply^battery voltage directly to
the terminals on the horn. If the horn sounds, check the switch (see
Section 17) and the wiring between the switch and the horn (see the
wiring diagrams at the end of this Chapter).
2 If the horn doesn't sound, replace it.
Replacement
3 Unbolt the horn bracket from the frame (see illustration 21.1) and
detach the electrical connectors.
22.4 Disconnect the cable that runs to the starter
A Cable to starter
B Cable from battery positive terminal
C Two-wire connector
4 Unbolt the horn from the bracket and transfer the bracket to the
new horn.
5 Installation is the reverse of removal.
22 Starter relay - check and replacement
Refer to illustration 22.4
Check
1 Remove the seat (see Chapter 7). Disconnect the battery negative
cable.
2 Make sure the battery is fully charged and the relay wiring
connections are clean and tight. Corrosion can build up enough to
prevent current flow and still not be readily visible, so it's best to
disconnect the cables from the terminals and give the cable ends and
terminal studs a thorough cleaning. Also disconnect the two-wire
connectors and clean the terminals.
3 Reconnect the wires to the starter relay.
4 Warning: Make sure the transmission is in neutral for this step.
Pull back the protective cover and disconnect the cable that runs from
the relay to the starter motor (see illustration). Connect a heavy-
gauge jumper wire (the same gauge or heavier than the starter relay
315

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Yamaha-XV750-Virago

Zoeken resetten

  • Beste....
    Ik ben in het bezit van een yamaha xv750 virago 1993 waarvan het stuur 6cm. te breed is om door een deur te gaan , mijn vraag is: kan ik ongestraft aan beide zijde van het stuur 3cm afzagen en dan de handvatten weer terug plaatsen , of veranderd er veel in het stuurgedrag ?
    Heeft er iemand ervaring hier mee?
    Bij voorbaat dank voor uw moeite ,
    Met vriendelijke groet Kees Gesteld op 13-1-2024 om 12:24

    Reageer op deze vraag Misbruik melden
  • hoe carbeurator kuisen liefst in nederlandse handleiding Gesteld op 28-11-2022 om 22:35

    Reageer op deze vraag Misbruik melden
  • Mijn motor stopt na een tijdje en als ik even wacht start die weer. Dit herhaalt zich telkens weer volgens kenners iets met de ontsteking, dus niet met de brandstof daar is al naar gekeken.
    Gr.Theo Gesteld op 20-8-2022 om 10:32

    Reageer op deze vraag Misbruik melden
  • Goede middag,
    Heb een nieuw rubber (Gasket) voor het achterlicht. In de handleiding staat niet hoe ik het achterlicht moet verwijderen en het rubber moet plaatsen. Graag antwoordt Gesteld op 31-10-2021 om 12:54

    Reageer op deze vraag Misbruik melden
  • Kan ik zonder problemen de toerenteller verwijderen van mijn Yamaha virago bj1992? Gesteld op 25-4-2020 om 21:49

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yamaha XV750 Virago bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yamaha XV750 Virago in de taal/talen: Engels als bijlage per email.

De handleiding is 52,61 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info