11
English
ACTIVE SERVO TECHNOLOGY
The theory of Active Servo Technology is based upon two
major factors, the Helmholtz resonator and negative-
impedance drive. Active Servo Processing speakers
reproduce the bass frequencies through an “air woofer”,
which is a port or opening in the speaker’s cabinet. This
opening is used instead of, and performs the functions of, a
woofer in a conventionally designed speaker system.
Thus, signals of low amplitude within the cabinet can,
according to the Helmholtz resonance theory, be output
from this opening as waves of great amplitude if the design
is such that the size of the opening and the volume of the
cabinet are in the correct proportion to satisfy a certain
ratio.
In order to accomplish this, moreover, the amplitudes within
the cabinet must be both precise and of sufficient power
because these amplitudes must overcome the “load”
presented by the air that exists within the cabinet.
Thus it is this problem that is resolved through the
employment of a design in which the amplifier functions to
supply special signals. If the electrical resistance of the voice
coil could be reduced to zero, the movement of the speaker
unit would become linear with respect to signal voltage, and,
to accomplish this, a special negative-impedance output-drive
amplifier for subtracting output impedance of the amplifier is
used.
By employing negative-impedance drive circuits, the amplifier
is able to generate precise, low-amplitude low-frequency
waves with superior damping characteristics, and these waves
are then radiated from the cabinet opening as high-amplitude
signals. The system can, therefore, by employing the
negative-impedance output drive amplifier and a speaker
cabinet with the Helmholtz resonator, reproduce an extremely
wide range of frequencies with amazing sound quality and
less distortion.
The features described above, then, are combined to be the
fundamental structure of the Active Servo Technology.
REMOVING THE FRONT GRILLE
The front grille is fastened to the enclosure at four points, and
can be removed if desired. To remove the grille, first hold the
bottom of the grille and unfasten the lower part of the grille by
pulling it gently, and then hold both sides of the grille and
slowly pull straight away from the speaker. To reattach, line
up the four pegs on the inside surface of the grille with the
four corresponding holes on the speaker and push gently.
Note
When the grille is removed, take care not to touch the
speaker unit with your hands or to exert excessive force with
tools.
Signals of low amplitude
Cabinet
High-
amplitude
bass
sound
Negative-impedance
output drive
Air woofer
(Helmholtz resonator)
Active Servo
Processing
Amplifier
Port
Signals
