516915
50
Verklein
Vergroot
Pagina terug
1/166
Pagina verder
En 50
CONNECTIONS
Setting up the speaker parameters automatically (YPAO)
Message list
When a warning message is displayed before measurement
Error messages
Warning messages
NOTE
If the following messages appear, resolve the problems that have occurred and carry out the
measurement process again.
Connect MIC! The YPAO microphone is not connected. Connect the YPAO microphone to the YPAO MIC
jack on the front panel.
Unplug HP! The headphones are connected. Remove the headphones.
Memory Guard! The settings of this unit are protected. Set “Memory Guard” in the Setup menu to “Off”
(p. 114).
E-1:
No Front SP
The unit was not able to find the front
channel.
Check that the left and right front speakers are
connected correctly.
E-2:
No Sur. SP
The unit was only able to find one of side
of the surround channels.
Check that the left and right surround speakers are
connected correctly.
E-3:
No F.PRNS SP
The unit was only able to find one of side
of the front presence channels.
Check that the left and right front presence speakers
are connected correctly.
E-4:
SBRSBL
Only one surround back speaker is
connected and only the right side surround
back channel sound is detected.
When only one surround back speaker is connected,
connect to the left side (SINGLE) terminal.
E-5:
Noisy
The noise is too loud, preventing accurate
measurements from being taken.
Measure again in quiet surroundings. Turn off any
devices in the room that may be emitting noise, or
place them further away from the YPAO
microphone.
When this message is displayed, selecting
“PROCEED” will allow you to continue measuring.
However, we recommend resolving the problem and
measuring again, as continuing measurement without
doing so will not give accurate results.
E-6:
Check Sur.
Even though surround left and right
speakers are not connected, only the
surround back speakers are connected.
When using surround back speakers, connection of
the surround left/right speakers is necessary.
E-7:
No MIC
The YPAO microphone has been removed. While measuring, take care not to touch the YPAO
microphone.
E-8:
No Signal
The YPAO microphone could not
distinguish a test tone.
Check that the YPAO microphone has been
installed correctly.
Check that each speaker has been connected and
installed correctly.
The YPAO microphone or the YPAO MIC jack may
be broken. Inquire at the retailer where you
purchased this unit, or the nearest Yamaha service
center.
E-9:
User Cancel
You have carried out an operation that has
cancelled the measuring process.
Carry out the measuring process again. Do not
operate this unit by, for example, adjusting the
volume.
E-10:
Internal Error
An internal error has occurred. Carry out the measuring process again. Contact a
Yamaha service center if “E-10” is displayed again.
E-11:
No R.PRNS SP
The unit was only able to find one of side
of the rear presence channels.
Check that the left and right rear presence speakers
are connected correctly.
W-1:
Out of Phase
The speakers displayed are connected with
the opposite polarity. Depending on the
type of speakers you are using and the
environment in which you have them
installed, this message may occur even if
the speakers are connected correctly.
Depending on the type of speakers, “W-1” may
display even if the speakers are connected correctly.
Check that the speaker polarity + (positive), and -
(negative) are correct. If these are connected
correctly, you can use the speakers normally even
this message appears.
W-2:
Over 24m/80ft
The speakers displayed are separated from
the listening position by more than 24 m,
and cannot be adjusted correctly.
Install the speakers with 24 m of the listening
position.
W-3:
Level Error
Volume level varies greatly for individual
channels, and cannot be adjusted correctly.
Check that all speakers are installed in the same
surroundings.
Check that the speaker polarity + (positive), and -
(negative) are correct.
We recommend the same speakers or speakers with
as similar specifications as possible.
Adjust the volume of the subwoofer.
If “W-2” or “W-3” appears, you can apply measurement results, but they will not give optimal
results. We recommend that you resolve the problem and carry out the measurement process again.
50

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yamaha RX-V3067 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yamaha RX-V3067 in de taal/talen: Engels als bijlage per email.

De handleiding is 22,2 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Yamaha RX-V3067

Yamaha RX-V3067 Snelstart handleiding - Nederlands - 8 pagina's

Yamaha RX-V3067 Gebruiksaanwijzing - Nederlands - 166 pagina's

Yamaha RX-V3067 Gebruiksaanwijzing - Deutsch - 166 pagina's

Yamaha RX-V3067 Snelstart handleiding - Deutsch - 8 pagina's

Yamaha RX-V3067 Snelstart handleiding - English - 8 pagina's

Yamaha RX-V3067 Gebruiksaanwijzing - Français - 166 pagina's

Yamaha RX-V3067 Snelstart handleiding - Français - 8 pagina's

Yamaha RX-V3067 Gebruiksaanwijzing - Italiano - 166 pagina's

Yamaha RX-V3067 Snelstart handleiding - Italiano - 8 pagina's

Yamaha RX-V3067 Gebruiksaanwijzing - Espanõl - 166 pagina's

Yamaha RX-V3067 Snelstart handleiding - Espanõl - 8 pagina's

Yamaha RX-V3067 Snelstart handleiding - Svenska - 8 pagina's

Yamaha RX-V3067 Gebruiksaanwijzing - Svenska - 166 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info