516914
133
Verklein
Vergroot
Pagina terug
1/160
Pagina verder
En 133
APPENDIX
Refer to the table below when this unit does not function properly.
If the problem you are experiencing is not listed below, or if the instructions below do not help, turn off this unit, disconnect the power cable, and contact the nearest authorized Yamaha dealer or service
center.
General
Troubleshooting
Problem Cause Remedy
See
page
The power will not
turn on.
The protection circuitry operated
3 times consecutively.
As a safety precaution, when the protection
circuitry operates 3 times consecutively, the
capability to turn on the power is disabled.
Contact your nearest Yamaha dealer or
service center to request repair.
The unit enters
standby mode soon
after the power is
turned on.
The power cable is not completely
inserted.
Connect the power cable properly to an AC
wall outlet.
(When this unit is turned back on
and “CHECK SP WIRES!” is
displayed.) The protection
circuitry has been activated
because this unit was turned on
while a speaker cable was shorted.
Make sure that all speaker cables between
this unit and speakers are connected
properly.
22
This unit cannot be
turned off or does
not work properly.
The internal microcomputer is
hung-up due to an external electric
shock (such as lightning or
excessive static electricity) or by a
drop in power supply voltage.
Disconnect the power cable from the AC
wall outlet, wait about 30 seconds and then
plug it in again.
The batteries in the remote control
may have lost their charge.
Replace all batteries. 13
The unit enters
standby mode.
The protection circuitry has been
activated because of a short circuit,
etc.
Check that the speaker with an impedance
of at least 6 Ω.
Check that the speaker impedance settings
are correct.
21
Check that the speaker wires are not
touching each other, then turn the unit back
on.
The sleep timer has turned off the
unit.
Turn on the unit, and play the source again.
After display of a
countdown on the
front panel, the unit
goes into standby
mode.
If you do not use take any action,
the Auto Power Down function
operates.
Turn on the unit, and play the source again.
In the Setup menu “Auto Power Down”
(“Function “Auto Power Down”),
increase the time until switching to standby
mode, or turn off the Auto Power Down
function.
107
No sound. Incorrect input or output cable
connections.
Connect the cables properly. If the problem
persists, the cables may be defective.
30
Speaker connections are not
secure.
Secure the connections. 22
The HDMI components connected
to the unit do not support the
HDCP copy protection standards.
Connect HDMI components that support the
HDCP copy protection standards.
The audio input into the device is
set to playback through the TV.
In the Setup menu, set the “Amp” of “Audio
Output” (“HDMI” “Audio Output”
“Amp”) to “On.
103
No appropriate input source has
been selected.
Select an appropriate input source with
Input selector.
47
The volume is turned down or
muted.
Turn up the volume.
Signals that this unit cannot
reproduce are being input from a
source component, such as a CD-
ROM.
Use an input source that has signals that can
be reproduced on this unit.
Problem Cause Remedy
See
page
133

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yamaha RX-V2067 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yamaha RX-V2067 in de taal/talen: Engels als bijlage per email.

De handleiding is 20,95 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Yamaha RX-V2067

Yamaha RX-V2067 Gebruiksaanwijzing - Nederlands - 8 pagina's

Yamaha RX-V2067 Gebruiksaanwijzing - Nederlands - 160 pagina's

Yamaha RX-V2067 Gebruiksaanwijzing - Deutsch - 160 pagina's

Yamaha RX-V2067 Snelstart handleiding - Deutsch - 8 pagina's

Yamaha RX-V2067 Snelstart handleiding - English - 8 pagina's

Yamaha RX-V2067 Gebruiksaanwijzing - Français - 160 pagina's

Yamaha RX-V2067 Snelstart handleiding - Français - 8 pagina's

Yamaha RX-V2067 Gebruiksaanwijzing - Italiano - 160 pagina's

Yamaha RX-V2067 Snelstart handleiding - Italiano - 8 pagina's

Yamaha RX-V2067 Gebruiksaanwijzing - Espanõl - 160 pagina's

Yamaha RX-V2067 Snelstart handleiding - Espanõl - 8 pagina's

Yamaha RX-V2067 Gebruiksaanwijzing - Svenska - 160 pagina's

Yamaha RX-V2067 Snelstart handleiding - Svenska - 8 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info