555564
9
Verklein
Vergroot
Pagina terug
1/88
Pagina verder
6 En
English
To achieve natural sound with an effective super-bass
component, you must adjust the volume and tone balance
between the subwoofer and the front speakers. Follow the
procedure described below.
1. Set the VOLUME control to minimum (0).
2. Turn on the power to the component(s) connected to
the subwoofer.
If the component is connected to the subwoofer’s
SYSTEM CONNECTOR jack, turn on the power to
that component.
3. Set the POWER switch on the subwoofer to ON.
* The indicator lights green.
4. Play a source that contains low-frequency components
and adjust the output level of the front speakers using
the amplifier’s volume control to the desired listening
level. (Set all tone controls to flat.)
5. Adjust the HIGH CUT control to the position where the
desired response can be obtained.
Normally, set the control to a level a little higher than
the front speaker’s rated minimum reproducible
frequency*.
* The front speaker’s rated minimum reproducible frequency can
be looked up in the speakers’ catalog or owner’s manual.
* The HIGH CUT control has no effect on signals input to the
INPUT 3 LFE terminals.
6. Increase the volume gradually to adjust the volume
balance between the subwoofer and the front speakers.
Normally, set the control to a level where you can
obtain a little more bass effect than when the subwoofer
is not used.
7. Set the PHASE switch to the position which yields the
more natural (or preferable) phasing.
8. Set the B.A.S.S. switch to “MOVIE” or “MUSIC”
according to the played source.
MOVIE:
When a movie type source is played, the low-frequency
effects are enhanced to allow listeners to enjoy a more
powerful sound. (The sound will be richer and deeper.)
MUSIC:
When an ordinary music source is played, the excessive
low-frequency components are cut off to make the
sound clearer. (The sound will carry less bass and
reproduce the melody line more clearly.)
Note
Once the volume balance between the subwoofer and the front
speakers is adjusted, you can adjust the volume of your entire
sound system by using the amplifier’s volume control.
However, if you replace the front speakers, you will need to
make this adjustment again.
ADJUSTING THE BALANCE
Rear panel
PHASE switch
In most situations, set this switch to select the
reverse mode. However, depending on your speaker
systems or listening condition, there may be a case
when better sound quality is obtained by selecting
the normal mode. Select the better mode by
monitoring the sound.
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yamaha NS-SW500 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yamaha NS-SW500 in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans, Zweeds als bijlage per email.

De handleiding is 4,58 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info