555200
5
Verklein
Vergroot
Pagina terug
1/36
Pagina verder
5 En
English
When connecting the speaker cable
Do not let the bare speaker wires touch each other as this
could damage the speaker or the amplifier.
Make sure you connect the speakers with the correct
polarity—positive (+) terminals to positive (+)
terminals, and negative (–) terminals to negative (–)
terminals. If you get them crossed over, the sound will be
unnatural and lack bass.
Connect one speaker to the left (marked L) terminals of
your amplifier or receiver, and another speaker to the
right (marked R) terminals.
Please refer to the owner’s manual that came with your
amplifier or receiver.
How to connect the speaker cables
1. Loosen the terminal knob.
2. Remove 10 mm (3/8") of insulation from each end of the
cables, and twist the exposed conductors together neatly
and tightly, as shown below.
3. Insert the bare wire.
4. Tighten the knob and secure the cable.
5. Test the firmness of the connection by pulling lightly on
the cable at the terminal.
Notes
When using an amplifier with a rated output power higher
than the nominal input power of the speaker, care should be
taken never to exceed the speaker’s maximum input.
The speaker may be damaged if certain sounds are
continuously output at high volume level. For example, if sine
waves from a test disc, bass sounds from electronic
instruments, etc., are continuously output, or when the stylus
of a turntable touches the surface of a disc, reduce the volume
level to prevent the speaker from being damaged.
When using a banana plug
1. Tighten the terminal knob.
2. Simply insert the banana plug into the terminal.
The speaker and the grille are packed separately. To attach
the grille, line up the projections (magnets) on the reverse
side of the grille with their corresponding screw heads on
the speaker.
Notes
When removing the cover, be careful not to touch the drive
units, and not to exert excessive force with any tools.
Do not touch or apply impact to the speaker’s diaphragm.
Otherwise, the speaker may malfunction.
There are magnets on the reverse side of the grille. Do not
place the grille close to objects that might be affected by
magnets, such as CRT TV, clock, magnetic card, diskette,
etc., after removing it.
Type............................... 3-way bass reflex speaker system
Non-Magnetic shielding type
Driver...............................16 cm (6-1/2") cone woofer × 1
Advanced PMD
13 cm (5") cone mid-range × 1
Advanced PMD
3 cm (1") aluminum dome tweeter
DC diaphragm
Impedance ....................................................................6
Frequency Response ................40 Hz to 50 kHz (–10 dB)
100 kHz (–30 dB)
Nominal Input Power ...............................................40 W
Maximum Input Power..........................................160 W
Sensitivity .................................................88 dB/2.83 V/m
Crossover Frequency............................... 580 Hz/4.1 kHz
Dimensions (with legs) (W × H × D)
.................. 224 × 981 × 349 mm (8-7/8" × 38-5/8" × 13-3/4")
Weight............................................. 19.1 kg (42 lbs. 2 oz.)
* Specifications subject to change without notice due to
product improvements.
* A speaker cable is not included with this model.
ATTACHING THE GRILLE
Banana plug
SPECIFICATIONS
5

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yamaha NS-F500 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yamaha NS-F500 in de taal/talen: Duits, Engels, Frans, Spaans als bijlage per email.

De handleiding is 2,02 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info