Tape A or tape B playback
1 Press the TAPE input selector button.
2 Open the DECK A or DECK B cassette compartment by
pressing the EJECT button.
3 Load the tape into the DECK A or DECK B cassette
compartment, and close the lid panel completely by
pressing the panel until it clicks.
* If you have loaded two tapes into both the DECK A and
B cassette compartments, select the DECK A or B in
which the tape you want to play back is loaded by
pressing the DECK A/B button so that the
corresponding indicator lights up.
4 Select the Dolby NR B or C position by pressing the
DOLBY NR button once or more so that the
corresponding indicator lights up, if the tape has been
recorded with Dolby noise reduction. If not so, set the
DOLBY NR button so that neither of the indicators lights
up.
* For selection of the Dolby B or C position, refer to the
“Dolby B and C Type Noise Reduction” on page 23.
5 If necessary, switch the reverse mode to the desired one
by pressing the reverse MODE selector button so that the
corresponding indicator lights up.
The reverse MODE selector button can be operated before
or during playback, and changes tape playback as follows:
6 Press the play button to listen to side A, or the
play button for side B.
To stop playback
Press the stop button.
Note
When removing the tape, press the stop button, and
then open the cassette compartment.
Direct operation
Even if an input source other than tape deck is selected,
pressing the play button (or the fast wind button) will start
playback (or fast winding) directly.
TAPE DECK OPERATION
21
DECK A/B button
