E-16
TUNING OPERATION
Preset tuning
This unit can store station frequencies selected by tuning
operation. With this function, you can select any desired
station by only calling the corresponding preset station
number.
Up to 20 stations (10 FM and 10 AM stations) can be stored
by using the 10 preset station numbers. (One preset station
number can be stored with one FM station and one AM
station separately by switching the reception band.)
To store stations
(Example: To store a FM station to the preset station
number 1)
1 Select the reception band [FM or AM] by pressing the
FM/AM button while watching the display.
(In this case, select “FM”.)
2 Tune to a desired station.
(Refer to the previous page for tuning procedure.)
3 Press the tuner MEMORY button.
* The MEMORY indicator will flash for about 10 seconds.
4 Select a preset station number to which you will store the
selected station by pressing the corresponding preset
station number button on the remote control transmitter
before the MEMORY indicator goes out.
(In this case, select “1”.)
* “P1” will appear on the information display area.
* Preset station number can also be selected by pressing
the PRESET ( / ) buttons on the front panel
repeatedly.
5 Within about 10 seconds, press the tuner MEMORY
button again.
* The MEMORY indicator will stop flashing and light up.
It shows the displayed station frequency has been
programmed to the preset station number 1.
In the same way, program other FM stations to the preset
station number 2 to 10.
Note
The preset station number 10 is shown by “0” on the display.
Store desired AM stations in the same way
AM stations can also be stored to the preset station numbers
1 to 10 in the same procedure described above.
1, 11 4 3, 5
4, 22
1, 11
