E-12
COMPACT DISC PLAYER OPERATION
Program play
You can program up to 30 tracks in any desired order.
1 Load a disc and close the disc table.
2 When in the stop mode, press the PROG button to
prepare for programming.
* “PGM” and “P- 1” will light up on the display, and “01”
will begin flashing.
3 Use the track number input buttons to select the desired
track number.
* The selected track number and the next playback order
will appear on the display, and soon it is replaced by
the display of the total play time of the programmed
tracks. Programmed track numbers will light up on the
music calendar.
* For example, to choose selection 12
(1)Press the “+10” button.
(2)Within 8 seconds, press the “2” button.
4 Repeat step 3 for any other track. Up to 30 tracks can be
programmed.
5 Press the play/pause button to start playback of
programmed tracks.
Notes
•
If the total time of the programmed tracks reaches 100
minutes or more, the time will not be displayed.
•
The total time of the programmed tracks will not be
displayed, if a track number higher than 30 is
programmed.
•
Skip search and manual search can be performed during
playing back, but only within the range of the programmed
tracks.
To stop program play
•
Press the stop button.
•
To resume playback, press the
play/pause / button. Playback will begin from the
beginning of the program.
To cancel a programmed sequence
There are two methods as described below.
•
Open the disc table
•
Switch off the power.
To check program data
1. If during playing back or if the track number indicator is
flashing, press the stop button.
2. Each time the button is pressed, the track numbers
and sequential order of the programmed tracks can be
checked one after another. The display of the track
number can be returned (sequentially in reverse order) by
pressing the button.
