17
English
Adjusting the output level balance among all the channels are
very important to maximize the performance of your system
including this unit. This unit lets you adjust the sound output level
balance among the left main, center, right main, right surround and
left surround channels using the built-in test tone generator. If your
amplifier (or receiver) connected with this unit is equipped with the
Dolby Pro Logic Surround Decoder, you should make the output
balance adjustment for Dolby Pro Logic on the amplifier (or
receiver) connected with this unit, before making the adjustment
on this unit. Follow the instructions below.
BEFORE MAKING THE ADJUSTMENT ON THIS UNIT
Be sure to adjust the output level balance among the left
main, center, right main and surround channels for Dolby Pro
Logic on the amplifier (or receiver) connected to this unit
using a test tone generator built into the amplifier. Adjust the
balance so that the levels of those channels become almost
the same when you hear the test tone at the listening
position.
If you have finished adjusting the output balance on the
amplifier, then go on to the adjustment on this unit by
following the procedure below.
1. Turn down the volume to a minimum level on the amplifier or
receiver.
2. Press the TEST switch.
3. Turn up the volume on the amplifier or receiver.
You will hear a test tone (like pink noise) from the left main
speaker, then the center speaker, then the right main speaker,
then the right surround speaker and then the left surround
speaker, for about two seconds each. The display changes as
shown below.
NOTE: If not using a center speaker, be sure to set the function “1.
CENTER SPEAKER” in the SET MENU mode to the PHNTM
(phantom) position. You will then hear the center channel test tone
from the left and right main speakers.
OUTPUT BALANCE ADJUSTMENT
(Center)
(Left main)
(Right main)
(Right surround)
(Left surround)
