517061
39
Verklein
Vergroot
Pagina terug
1/89
Pagina verder
34 02R Applications
Yamaha 02R & 03D Applications Guide
12
Two 02Rs with Four DA-88s
This application shows how two 02Rs can be used with four Tascam DA-88s to create a
48-input, 32-track digital recording system. The 32 digital tape returns and 48 Mic/Line
inputs provide up to 80 inputs at mixdown.
The two 02Rs are cascaded together using a 25-pin straight cable and two CD8-CS Cascade
cards, which are installed in Slot [3] of each 02R (could be Slot [4]). The cascade
connection carries the eight buses, any four of the eight AUX buses, Stereo bus, and Solo
bus. This allows both consoles to work together as one large 80-input mixing console. The
master section of 02R–B is used for monitoring and two-track operations. The studio
monitors and two-track recording equipment are also connected to this 02R.
Connections
The Tascam (CD8-TD) cards must be screwed securely in place. Do not leave the screws
out after installation as the cards will not be grounded correctly.
DA-88–A is connected to Slot [1] of 02R–A and the tape inputs correspond to tracks one
through eight (Tape In 1–8). DA-88–B is connected to Slot [2] of 02R–A and the tape
inputs correspond to tracks nine through sixteen (Tape In 9–16). DA-88–C is connected
to Slot [1] of 02R–B and the tape inputs correspond to tracks 17 through 24 (Tape In
1–8). DA-88–D is connected to Slot [2] of 02R–B and the tape inputs correspond to
tracks 25 through 32 (Tape In 9–16). PW-88DL cables are available from Tascam.
The optional SY-88 Sync Board is required for DA-88–A. This enables the dedicated
timecode track, which can be re-striped at anytime, and provides SMPTE timecode and
MTC outputs. A timecode offset can be specified on DA-88–A.
02R Wordclock Setup
On the DIGITAL I/O menu, the wordclock source should be set to W.CLK.
DA-88 Wordclock Setup
DA-88–A works as wordclock master. Wordclock is fed to the 02R using a BNC to BNC
cable, and to the other DA-88s using PW-88S 15-pin sync cables, available from Tascam.
The sampling rate is set when the DA-88 tapes are formatted. This can be either 48 kHz or
44.1 kHz. After formatting, the sampling rate is determined by the formatted tape.
Notes
The DA-88s must be powered up even when they are not being used. Failure to do so may
cause an intermittent pumping noise on the 02R.
DA-88–A is set to MACHINE ID to 0, DA-88–B to MACHINE ID to 1, DA-88–C to
MACHINE ID 2, and DA-88–D to MACHINE ID 3. Since DA-88–A works as the
Control Master, it should be used for synchronized transport and locate operations.
The optional Tascam SY-88 Sync Board must be installed in DA-88–A to use SMPTE
timecode and MTC. This is available from Tascam. The other DA-88s do not require
SY-88 Sync Boards and their tapes do not have to be striped with timecode. They are
synchronized to DA-88–A via the PW-88S 15-pin sync cables.
The terminator bundled with a PW-88S sync cable should be connected to the SYNC
OUT on DA-88–D to ensure reliable synchronization.
The rear panel of the SY-88 Sync Board has a DIP switch labeled MODE. Set DIP
switches 2 and 5 to ON (O). Set internal switch 8 on the SY-88 board marked S2 to ON.
To use the MTC function, the SY-88 firmware must be version 3.08 or higher.
39

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yamaha 03D bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yamaha 03D in de taal/talen: Engels als bijlage per email.

De handleiding is 2,46 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Yamaha 03D

Yamaha 03D Gebruiksaanwijzing - Nederlands - 302 pagina's

Yamaha 03D Gebruiksaanwijzing - Deutsch - 307 pagina's

Yamaha 03D Gebruiksaanwijzing - Français - 300 pagina's

Yamaha 03D Gebruiksaanwijzing - Italiano - 301 pagina's

Yamaha 03D Gebruiksaanwijzing - Português - 141 pagina's

Yamaha 03D Gebruiksaanwijzing - Espanõl - 315 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info