478504
103
Verklein
Vergroot
Pagina terug
1/132
Pagina verder
Page 101FT-950 OPERATING MANUAL
Most RTTY operation today is accomplished using a TNC or other computer-based system that utilizes AFSK tones. As
such, the previous discussion on LSB-mode “Packet” operation will apply for Baudot operation, as well. For RTTY opera-
tion using a Terminal Unit (TU) or the “FSK” output from a TNC, please see the discussion below. See also the illustration
for details regarding connection to your TU.
SETTING UP FOR RTTY OPERATION
Before commencing RTTY operation, please direct your atten-
tion to the setup steps shown in the chart to the right.
BASIC SETUP
RTTY
(
RADIO TELETYPE
)
O
PERATION
1. To engage RTTY operation using “LSB” injection,
which is generally used in the Amateur service. Press
the
[
RTTY/PKT
]
button repeatedly until both the
” and “ ” icons appear on the display.
2. To switch to USB-side injection in RTTY, press and
hold in the
[
RTTY/PKT
]
button. Both the “ ” and
” icons will appear on the display.
3. When you begin typing on your TU or computer key-
board, the command to transmit should automatically
be sent to the transceiver, causing it to enter the trans-
mit mode.
NOTE:
If you anticipate making data transmissions of longer than
a few minutes, we recommend that you reduce the trans-
mitter power to 1/3 ~ 1/2 of its normal maximum via the
Menu item “111 TGEN TX PWR”.
ADVICE:
If you need to adjust the output level from the “DATA
OUT” pin (pin 5) of the RTTY/PKT jack on the rear
panel of the transceiver, please use Menu item “061
RTTY OUT LVL”. For the input level from the TU, there
is no adjustment of the FSK input level (Pin 4) of the
RTTY/PKT jack. Please make any needed level ad-
justments at the TU side.
TO
1
ANT
DC IN
2
FROM
GND
ROT LINEAR TUNER PTT REC REM KEY
DMU CAT
EXT
SPKR
INPUT: DC 13.8 V
22 A
-TUNE
-TUNE
AF
IN PTT
FSK
OUT
F
S
K
I
N
D
A
T
A
O
U
T
D
A
T
A
P
T
T
G
N
D
TU
N.C.
GND
PTT
FSK OUT
AF IN
N.C.
RTTY/PKT JACK
DATA IN (Pin 1)
Pin 6
GND (Pin 2)
DATA PTT (Pin 3)
FSK IN (Pin 4)
DATA OUT (Pin 5)
SQL OUT(
)
MENU ITEM AVAILABLE VALUES
059 RTTY R PLRTY nor
(
normal
)
/ rEU
(
reverse
)
060 RTTY T PLRTY nor
(
normal
)
/ rEU
(
reverse
)
061 RTTY OUT LEL 0 ~ 100
062 RTTY SHIFT 170/200/425/850
(
Hz
)
063 RTTY TONE 1275/2125
(
Hz
)
The Mark/Space Shift utilized in most Amateur RTTY
operation is 170 Hz. Other shifts may be configured,
however, using Menu item “062 RTTY SHIFT”. The
FT-950 is set up for “high tone” operation (centered
on 2125 Hz) by default, but you may configure it for
low tone (1275 Hz) operation using Menu item “063
RTTY TONE”.
You may find that you are unable to decode some RTTY
stations, even if they are of sufficient signal strength.
If this is observed, there may be a Mark/Space polarity
problem between your station and the other station. If
so, try setting Menu item “059 RTTY R PLRTY” to
rEU” (“Reverse”) to see if that permits copy. A sepa-
rate Menu Item permits reversal of your transmitters
Mark/Space polarity: “060 RTTY T PLRTY”.
QUICK POINT:
In the FT-950, “RTTY” is a mode defined as being an
“FSK” mode, whereby the closing and opening of a key-
ing line (to ground) causes the Mark/Space tones to alter-
nate. The RTTY mode is not an AFSK based mode in this
transceiver, and the AFSK output tones from a TNC will
not cause Mark/Space shifting to occur. Use the “Packet”
mode for AFSK-based Baudot and other data modes.
103

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Yaesu-FT-950

Zoeken resetten

  • Ft950 wil niet zenden met jtdx in ft8 ontvangt wel goed settings staan volgens Manuel ingesel, e weet raad? 73 PD4 PG Gesteld op 22-7-2024 om 22:04

    Reageer op deze vraag Misbruik melden
  • Bij het opstarten knippert TX. Ontvangst doet het, maar zenden niet. Wie heeft een oplossing? Gesteld op 15-4-2024 om 14:09

    Reageer op deze vraag Misbruik melden
  • Hoe sluit ik een digibox (MMSTV) aan op een FT950? Gebruikte voorheen een FT575GX2 . Deze had 3 tulpstekkertjes. Audio in audio uit en PTT ontvangst werkt goed en de zender schakelt ook in. Audio signaal klinkt niet zoals het hoort. Gesteld op 28-7-2023 om 19:00

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Yaesu FT-950 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Yaesu FT-950 in de taal/talen: Engels als bijlage per email.

De handleiding is 6,67 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info