Copy WorkCentre
®
5845/5855/5865/5875/5890
76 User Guide
Preparing Copies to be made into a Booklet
When you press the Start button to make a copy, the device scans your originals and temporarily
stores the images. It then prints the images based on the selections made.
If Authentication or Accounting has been enabled on your device you may have to enter login
details to access the Copy features.
Depending on the optional finishing device and kits installed you will have the choice of different
output options such as stapling, folding and collating.
Use the Booklet options to automatically produce folded and stapled booklets. A cover can be
inserted onto the booklet automatically.
Use the Booklet Creation option to automatically reduce and arrange the images in the correct
sequence on your selected media, so that a booklet is created when the copy set is folded in half.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
3. Press the Services Home button.
4. Select the Copy button on the touch screen. The copy features are displayed.
5. If required, select the Copy tab. This is usually the active tab when the Copy service opens.
6. If required, select the More... button at the bottom of the Copy Output section to access all the
finishing options. The number of options displayed will depend upon the finishing device and
kits installed (there may not be enough to require a More... button).
7. Select the Booklet Creation option required.
• Off select this option if you want your output layout to match your originals. For example,
if your originals are already in a booklet layout.
• On select this option if you want the device to automatically reduce and arrange the
images to create a booklet layout.
8. Select the Finishing option required.
• Folded & Stapled will staple and fold the output along the center margin to produce
stapled booklets.
• Fold Only will fold the output along the center margin to produce loose leaf booklets.
• None select this option if you do not want the device to fold and staple your output.
9. Select the OK button.
10. Enter the number of prints required using the numeric keypad on the control panel.
11. Press the Start button on the control panel to scan the original.
12. Remove the original from the document feeder or document glass when scanning has
completed. The job enters the job list ready for processing.
13. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
