Copy WorkCentre
®
5845/5855/5865/5875/5890
User Guide 71
11. Remove the original from the document feeder or document glass when scanning has
completed. The job enters the job list ready for processing.
12. Press the Job Status button on the device control panel to view the job list and check the status
of the job.
13. If your job remains held in the Active Jobs list, the device needs you to supply additional
resources, such as paper or staples before it can complete the job. To find out what resources
are needed, select the job and then select the Details button. Once the resources are available
the job will print.
More Information
Using the None Output Option for Copies
Collating Copies
Stapling Copies
Hole Punching Copies
Preparing Copies to be made into a Booklet
Making Copies into Tri-Folded Pages
Using a User ID to Log In at the Device
Viewing the Progress and Details of a Job using the Job Status Menu
Describing the Finishing Devices
Identifying the WorkCentre® 5845 Standard and Optional Services
Identifying the WorkCentre® 5855 Standard and Optional Services
Identifying the WorkCentre® 5865 Standard and Optional Services
Identifying the WorkCentre® 5875 Standard and Optional Services
Identifying the WorkCentre® 5890 Standard and Optional Services
Using the None Output Option for Copies
When you press the Start button to make a copy, the device scans your originals and temporarily
stores the images. It then prints the images based on the selections made.
If Authentication or Accounting has been enabled on your device you may have to enter login
details to access the Copy features.
Depending on the optional finishing device and kits installed you will have the choice of different
output options such as stapling, folding and collating.
Use the No Finishing option if no finishing is required for the output.
1. Load your documents face up in the document feeder input tray. Adjust the guide to just touch
the documents.
Or
Lift up the document feeder. Place the document face down onto the document glass and
register it to the arrow at the top left corner. Close the document feeder.
2. Press the Clear All button on the control panel to cancel any previous programming selections.
3. Press the Services Home button.
4. Select the Copy button on the touch screen. The copy features are displayed.
5. If required, select the Copy tab. This is usually the active tab when the Copy service opens.
6. If required, select the More... button at the bottom of the Copy Output section to access all the
finishing options. The number of options displayed will depend upon the finishing device and
kits installed (there may not be enough to require a More... button).
7. Select None from the Copy Output section.
