809330
20
Verklein
Vergroot
Pagina terug
1/28
Pagina verder
ERROR MANAGEMENT
6 720 642 344 (2010/01)
20
8 ERROR MANAGEMENT
The control unit has an advanced monitoring system that
gives alarms if anything unforeseen happens. The
customer can correct most alarms themselves. There is
never a risk of affecting something when an alarm is
reset once or twice. Contact the dealer/service engineer
in the event of repeated alarms.
8.1 EXAMPLE OF AN ALARM:
When an alarm is triggered, an alarm window is
displayed and a warning signal sounds. The alarm
window displays the alarm causes and the time and date
that the alarm occurred.
Fig. 48
If you press the menu dial whilst Acknowledge is
highlighted, the alarm symbol is cancelled from the
display and the alarm log, and the alarm buzzer is
silenced. The alarm signal continues to be shown if a
fault is not remedied. The ON and fault indicators
change from flashing red to constant red indications.
Every alarm is stored in the fault log. Active alarms are
indicated by the alarm symbol.
8.2 DIMMED MENU DISPLAY
8.2.1 POSSIBLE CAUSE 1: FAULTY FUSE IN THE
DOMESTIC POWER SUPPLY.
BCheck whether all domestic fuses are OK.
BIf required, change/reset fuse/MCB.
After the fault has been remedied, the heat pump
restarts automatically 15 minutes later.
8.2.2 POSSIBLE CAUSE 2: AN MCB IN THE CONTROL
PANEL OR IN THE INTERNAL UNIT HAS
TRIPPED.
BContact the dealer.
8.3 EMERGENCY MODE
The emergency function is available for the electric
additional heater in the internal unit. Information in this
connection is contained in the operating instructions of
the internal unit.
In emergencies heat generation is covered by the
electric additional heater. This enables heat to be
provided until the customer service remedies the fault.
8.4 ALL ALARMS AND WARNING
WINDOWS
An alarm can occur temporarily due to various reasons.
However, there is never a risk involved in resetting an
alarm. All the alarms that can appear in the menu display
are described in this section. The descriptions give an
idea about the nature of the alarm and what can be done
to rectify it.
The alarm log (see Advanced menu) shows the alarms
and warnings that have occurred.
8.4.1 LIST OF ALL ALARMS:
Tripped low pressure switch
Tripped high pressure switch
Failure / Short circuit on sensor.
Faulty function in 4-way valve
T6 High hot gas temperature
Fault on electric additional heat
T8 High flow temperature.
Low temperature in condenser
Tripped motor cut-out
Air/Water pump not connected
Fault in I/O card control cabinet/electric boiler
Tripped motor cut-out fan
8.4.2 LIST OF ALL WARNINGS:
Is the heat pump fused for this output?
High temperature difference heat transfer fluid
8.4.3 LIST OF ALL INFORMATION WINDOWS
Heat pump is now working at its highest permitted
temperature
Add. heat is now working at its highest permitted
temperature
This setting means that additional heat can take
over operation
Temporary stop of hot water production
Temporary stop of compressor operation
6 720 641 467-19.1I
Emergency mode should not be mistaken
for alarm mode. In alarm mode the heat
pump stops. Heat generation continues to
be regulated by the control unit.
20

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Worcester Greensource bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Worcester Greensource in de taal/talen: Engels als bijlage per email.

De handleiding is 2.1 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info