66
6. When using a 3in1 product, the indicators for the rinse aid and water softener are
no longer useful. It may be helpful to set the water hardness to the smallest
possible value.
How to select the 3in1 programme
1. Press the ON/OFF button and select the 3in1 programme by pressing the 3in1
button until the 3in1 indicator flashes.
2. The 3in1 programme is available after you pressed the 3in1 button and the 3in1
indicator is on.
How to cancel the 3in1 programme
1. Follow the instructions in HOW TO CHANGE A PROGRAMME. If you want
to operate the appliance with a standard detergent system again, then proceed as
follows:
a. Fill the water softener and the rinse aid container.
b. Set the water hardness to the highest possible value and let the appliance
operate for 3 normal wash-cycles without load.
You can put dishes later in the appliance unless the detergent container has opened.
1. Open the door slightly to stop operation.
2. You can open the door completely after the rotating spray arms stopped
operation.
3. Now you can add dishes.
4. When you close the door, the appliance starts operating after 10 seconds.
When the display indicates "-" and the acoustic signal sounds 6 times, the programme
has ended.
1. Switch off the appliance (ON/OFF button).
2. Turn off the water.
3. CAUTION! Wait a few minutes before you open the door as hot
damp may escape.
4. Wait approx. 15 minutes before you take out the dishes. The dishes are still hot
and will break easily.
5. It is normal that the appliance is wet inside.
