Do not use any aggressive detergents to remove residues of the
transportation lock.
4. Clean and maintain the appliance regularly to enable its proper
operation and optimal performance.
5. Take the enclosed parts from the packaging and its polystyrene-
components.
6. Check that the power cord and the appliance are not damaged before
electrical connection.
7. The rating plate must not be removed or made illegible, otherwise
all terms of the warranty become invalid!
SAVE THESE INSTRUCTIONS.
The manufacturer and distributor are not responsible for any damage or
injury in the event of failure to comply with these instructions.
2. Installation
WARNING! Do not lead the exhaust air into a chimney which is used
for extracting exhaust air of appliances operated by gas or other
combustibles.
1. For extracting the exhaust air always observe the current legal regulations.
2. The diameter of the exhaust hose must meet the diameter of the connecting ring.
3. The load-bearing capacity of the wall/ceiling
of the installation room must be
checked before you install the appliance.
4. The appliance must be installed at a suitable position only.
5. Before you install the appliance, check that there are not any electrical or other
cables in the installation area; this prevents these cables from being drilled
unintentionally.
6. Clean the environment thoroughly before installation. This prevents dust or
rubble from being sucked in during initial operation of the appliance.
7. During installation ensure that the extractor hood is in horizontal position in
order to avoid accumulations of fat in one corner of the appliance.
8. If your appliance is equipped with a carbon filter, remove the carbon filter before
you operate the appliance in the extraction mode. The carbon filter should be
used in the recirculating mode only.
9. The exhaust duct should be as short and straight as possible. The diameter of the
exhaust hose should be at least 120/150 mm (look at chapter TECHNICAL DATA).
