653511
8
Verklein
Vergroot
Pagina terug
1/44
Pagina verder
8
Test out which setting suits your personal preference.
The grinding process begins once the start/stop button has been
pressed (6). The motor only runs if the collection container (7) has
been put in place properly.
Once the required amount of coffee has been ground, the mill shuts
off automatically.
The grinding process can be interrupted at any time by pressing the
start/stop button (6) again.
Wait until the motor has stopped before removing the collection con-
tainer (7). Press down slightly when removing the collection container
(7). The coffee powder can be placed directly in the coffee machine
filter.
To avoid loss of aroma, coffee should only be milled for immediate use.
Excess coffee grounds can be kept in the collection container (7). Then
close the collection container (7) with the rubber cap (1).
Important information:
If the mill does not run, the motor may be obstructed by a bean. In
this case select a higher degree of fineness. Once the motor is running
the desired degree of fineness can be immediately reselected after
start-up.
If the motor still does not start, or has difficulty starting up at the
highest degree of fineness, clean the mill as described under „Cleaning
and Care“.
Cleaning and care
Warning! Remove from the mains before cleaning. Under no circum-
stances submerge the device in water - wipe the outside with a damp
cloth instead.
Do not use scourers.
Remove the collection container (7) and clean with a mild cleaning
product. Dry well before replacing the collection container (7).
Remove the remaining beans before removing the bean hopper (3).
Clean the bean hopper (3) and bean hopper cap (2) in dish water and
dry well. The mill can be opened when malfunctions occur or for clea-
ning. Remove the bean hopper (3) and then remove the mill ring (8).
Clean the mill and the mill ring (8) with a small brush or the cleaning
brush included in delivery (9).
Warning: The mill has sharp edges - there is danger of injury.
Replace the mill ring (8) and turn until it clicks into place and only
moves slightly.
Important: The safety ring must be turned in a clockwise direction as
far as it can go (see illustration) before the bean hopper (3) is replaced.
Otherwise the bean hopper (3) cannot be put back in place. Should
the safety ring be incorrectly replaced during cleaning, you can turn it
manually to the left.
8

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Wmf 0417020021 Skyline bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Wmf 0417020021 Skyline in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Spaans, Deens, Zweeds, Noors, Fins als bijlage per email.

De handleiding is 4,2 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info