745741
21
Verklein
Vergroot
Pagina terug
1/52
Pagina verder
21
Installation Instructions
Before You Start
Figure 1 is a cross-sectional view of your wood-burning stove. Here you
can gain an overview of the parts of which your stove consists.
1. Steel smoke deector.
2. Vermiculite smoke deector.
3. Vermiculite rear plate.
4. Vermiculite base plates.
5. Grate.
6. Vermiculite front piece.
7. Heat shield.
8. Air-regulation damper.
Please note: The combustion chamber is covered with plates made of
vermiculite, which is a heat-insulating material. These plates ensure
that the optimal combustion temperature is quickly reached, and they
must therefore remain inside in the wood-burning stove.
The steel smoke deector and the vermiculite smoke deector ensure that the passage of
smoke through the stove is as long as possible, so that the ue gasses have more time to emit
their warmth within the stove and the surrounding area. In this way you get more warmth from
the wood you add to the stove, as the warm smoke is not simply sent out through the chimney.
Arrangement of Individual Components
It is important to ensure that all individual components are in place and no damage was done
to them during transport. In Figure 1 you can see the parts that you must inspect:
1.
The steel bafe plate is hung from two hooks and equipped with two pins that serve as
protection during transportation. Remember to remove the two pins before you start using
the stove. Lift the skamol bafe plate off the combustion chamber and pull the two pins free
from the hooks.
2. The vermiculite smoke deector should rest on the side plates and be pushed all the way
back in the combustion chamber.
3. The rear plate must be pushed all the way back in the combustion chamber.
4. The base plates must lie at on bottom around the grate.
Only when you are condent that the individual components are in place, you may begin with
the installation of the wood-burning stove.
Changing the Smoke Outlet from Top Outlet to Rear Outlet
Proceed as follows to change the smoke outlet from top outlet to rear outlet:
1. Lift the top plate off the stove.
2. Remove the smoke ring on the top of the stove by unscrewing the three screws and lifting it off.
3. There is a cut-out for the ue duct in the back plate. Break off the plate within this cut-out to
make a hole that the ue duct can t into.
4. Remove the cover plate on the back of the stove by unscrewing the three screws (Torx Bit
no. 30) and lifting it off.
5. Install the cover plate on top of the stove with the three screws.
6. Place the smoke ring in the smoke outlet hole in the back of the stove and secure it with the
three screws.
7. Replace the top plate on the stove.
Fig. 1
1
2
3
4
5
6
8
7
21

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Wiking Volcanic 2 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Wiking Volcanic 2 in de taal/talen: Duits, Engels, Italiaans als bijlage per email.

De handleiding is 1,52 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Wiking Volcanic 2

Wiking Volcanic 2 Gebruiksaanwijzing - Nederlands, Français - 36 pagina's

Wiking Volcanic 2 Gebruiksaanwijzing - Dansk, Svenska, Norsk - 52 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info