10
Norsk
Installation Instructions
Before You Start (Figure A1/A2)
Figure A1/A2 is a cross-sectional view of your wood-burning stove. Here you can gain an overview
of the parts of which your stove consists.
WIKING Luma 1+3+5
1. Steel bae plate.
2. Vermiculite bae plate.
3. Vermiculite corner plates.
4. Vermiculite rear plate.
5. Vermiculite side plates.
6. Vermiculite side bottom piece.
Please note: The combustion chamber is covered with plates made of vermiculite, which is a
heat-insulating material. These plates ensure that the optimal combustion temperature is quickly
reached, and they must therefore remain inside in the wood-burning stove.
The steel smoke deector and the vermiculite smoke deector ensure that the passage of
smoke through the stove is as long as possible, so that the ue gasses have more time to emit
their warmth within the stove and the surrounding area. In this way you get more warmth from
the wood you add to the stove, as the warm smoke is not simply sent out through the chimney.
Arrangement of Individual Components (Figure A1/A2)
It is important to ensure that all individual components are in place and no damage was done
to them during transport. Check that all insulation plates of the combustion chamber have
been properly placed, i.e. that the bottom plate is horizontal and that the side plates are vertical
and reach all the way up to the steel sides of the combustion chamber and down to the
bottom plate.
In Figure A1/A2 you can see the parts that you must inspect:
1. The steel bae plate (1) is hung from two hooks and equipped with two pins (7) that serve
as protection during transportation. Remember to remove the two pins before you start
using the stove.
2. The vermiculite bae plate (2) must rest on the rear plate (4) and the Skamolex side plates
(5) must be pushed to the very rear of the combustion chamber.
3. The rear plate (4) must be pushed all the way back in the combustion chamber.
4. The corner plates (3), side plates (5) and side bottom pieces (6) must be pushed up
against the steel and rmly xed in the combustion chamber.
Changing the Smoke Outlet from Top Outlet to Rear Outlet
(WIKING Luma 1 - Luma 4)
Proceed as follows to change the smoke outlet from top outlet to rear outlet:
1. Lift the top plate o the stove.
2. Lift the rear plate o the stove.
3. Remove the smoke ring on the top of the stove by unscrewing the three screws and lifting it o.
4. There is a cut-out for the ue duct in the back plate. Break o the plate within this cut-out to
make a hole that the ue duct can t into.
5. Remove the cover plate on the back of the stove by unscrewing the three screws (Torx Bit
WIKING Luma 2+4+6
1. Steel bae plate.
2. Vermiculite bae plate.
3. Vermiculite corner plates.
4. Vermiculite rear plate.
5. Vermiculite side plates.
