34
NOTE 2: If it is hard to insert the infuser, before inserting it squeeze it to the right size by pressing it force-
fully from the top and bottom simultaneously, as shown in figure 27.
NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug from
the mains then plug in again.
Wait for all the lights to go off, then open the door and replace the infuser.
•replace the drip tray, complete with the grounds container;
• close the service door.
12 CHANGING AND SETTING THE MENU PARAMETERS
The following menu parameters and functions can be changed by the user:
• Clock
• Auto-start time
• Descaling process
• Coffee temperature
• Length of time the appliance remains on
•Water hardness
• Factory default values
12.1 Setting the clock
To set the clock, proceed as follows:
•Press the (the light over the button comes on) then press the button repeatedly until the
appliance displays
CLOCK 00:00
•Press the button to set the clock. (If you hold the , button down, the time is changed
rapidly).
•Press the button to confirm the value;
•Press the button to exit programming mode or to change other parameters.
When the appliance is in stand-by, you can see the hour by pressing one of the buttons (except the
button).
12.2 Setting auto-start time
This enables the time the appliance will come on automatically to be programmed.
• Make sure the clock on the appliance is set as described above.
•Press the button then press the button repeatedly until the appliance displays:
START TIME 00:00
•Press the button to set the auto-start time. (If you hold the , button down, the time is
changed rapidly).
•Press the button to confirm the value,
•Press once and the appliance displays the message:
AUTO-START NO
Press the button to modify the function (the appliance displays AUTO-START YES");
•Press the button to activate auto-start;
•Press the button to exit programming mode or the button to change other parameters.
