!
!
!
!
1.4. Product Views
!
!
1.4.1 Front View 1.4.2 Interface View
! !
Figure 1.1 Figure 1.2
!
!
1: Audio Out , 2: Audio In
3: Ethernet interface: RJ-45 interface. Power Supply Light: constant on after power up
Network light: constant sparkle after power up data transmission.
4: Antenna:
5: Power input interface: connect direct current 5V Power
6: TF Socket : No use for model :JW0004. Only use for model : JW0005.
!
!
1.5 Hardware Installation
!
Follow the steps below to set up your camera hardware. Make sure to follow each step
carefully to ensure that the camera operates properly
1. Install the Wi-Fi antenna (For wireless model) .
2. Plug the power adaptor into camera
3. Plug the network cable into camera, the other side to the router/switch
4. It takes approx 30 seconds to boot up the camera, then you will find the IP address from
“Search Tool” (Figure: 1.8)
5. When the power on and network cable connected, the green led of the real panel will keep
on, The yellow led will keep flash.
!