GB
19
W 550
Important Note regarding Product Liability!
Due to an EC ordinance in effect since 01.01.1990, the manufacturer is liable for his
product only if all parts originate from or were approved by the manufacturer and the
devices are assembled and operated correctly.
The use of other accessories and spare parts can partially or completely invalidate the
liability.
Problem Cause Remedy
No coating material emerges from Nozzle clogged Clean
the nozzle Feed tube clogged Clean
Material volume setting turned too far to
the left (-) Turn to the right (+)
Feed tube loose Insert
No pressure build-up in container Tighten container
Coating material drips from the Nozzle loose Tighten
nozzle Nozzle worn Change
Nozzle seal worn Change
Coating material build-up on air cap and
nozzle Clean
Atomisation too coarse Viscosity of coating material too high Thin
Material volume too large Turn material volume adjusting
Material volume adjusting screw turned too screw to the left (-)
far to the right (+)
Nozzle contaminated Clean
Air filter heavily soiled Change
Too little pressure build-up in container Tighten container
Spray jet pulsates Coating material in container running out Refill
Air filter heavily soiled Change
Coating material causes Too much coating material applied Turn material volume adjusting
"paint tears" screw to the left (-)
Too much fog of coating material Distance to the object too large Reduce distance
(Overspray) Too much coating material applied Turn material volume adjusting
screw to the left (-)
Correction of Malfunctions
