11
Operation
Maintenance
Cleaning (fig. W1)
Note: Disconnect electricity by unplugging cable at the socket
before proceeding. Attention: Keep hands clear of moving blade.
Clean mower thoroughly after each mowing with cloth or brush.
Do not spray with water. Keep mower in a dry room.
Change of cutter blade (fig. W2)
Note: always disconnect mains supply and wear
protective gloves before undertaking any work at the
cutter blades, cutter bar and blade coupling. Change
cutter blade using 10 mm spanner as illustraded.
Torque wrench setting for screws 8-10 Nm. Take care to carry
out this work thoroughly. Use original spare parts only.
Note: Sharpining of blades should be done by an
approved service centre as the correct balance of the
blade after sharpening is very important and ought to be
checked by an expert.
Winter Storage:
Clean mower thoroughly before storing away. Never spray
mower with water and do not store it in a wet or humid
place. Have your mower thoroughly checked once a year by
an approved Service Centre.
Please carefully retain the guarantee card completed by the seller,
or the proof of purchase.
The company WOLF-Garten provides a guarantee for 24 months from
the date of purchase. This guarantee is in accordance with the relevant
state of technology and the utilisation purpose / area of application. The
consumer‘s statutory rights are not affected by the following guarantee
guidelines.
Pre-conditions for the 24-month guarantee entitlement:
- Deployment of the device solely for private use.
The guarantee is reduced to 12 months in the commercial sector
or leasing business.
- Proper handling and observance of all information given in the
operating manual, which forms part of our guarantee terms.
- Observance of the prescribed maintenance intervals.
- No unauthorised alteration of the design.
Guarantee terms
- Installation of original WOLF replacement parts / accessories.
- Presentation of the completed guarantee card and/or proof of
purchase.
This guarantee does not extend to normal wear-and-tear on blades,
blade mounting components or friction disks, V-belts/toothed
belts, running wheels/tyres, air filters, spark plugs and spark plug
connectors. Any guarantee claim shall be immediately void in the
event of unauthorised repairs. Faults and defects which can be traced
to material or manufacturing faults will be rectified exclusively by our
contracted workshops (the seller has the right to remedy a defect) in
your vicinity, or by the manufacturer if the latter is closer. Any claims
going beyond the provision of a guarantee are ruled out. There is
no entitlement to a replacement. Any transport damage should be
reported not to us but to the shipper in question since, otherwise, any
compensation claims vis-à-vis the shipper would be voided.
Faults and how to remedy
Remedy (X) by:
Problem Possible cause
WOLF
service-workshop
Yourself
Uneven running, heavy
vibrations in the mower
• Blades damaged
• Blades loose in the fastening parts
X
---
---
X
Motor will not run
• Fuse blown
• Cable damaged
Important! If you inadvertently cut through the cable,
the fuse (10 Amp.) will not always blow. In the interest of
safety, never touch damaged or servered cables before
disconnecting the mains plug. Repairing the cable with
insulating tape is prohibited.
---
X
X
---
Poor mowing • Blunt blades X ---
Poor catching
• Blunt blades
• Catcher bag blocked
X
---
---
X
When in doubt, always consult a WOLF service workshop.
Important: switch off the mower and disconnect the mains plug before inspecting, cleaning or working on the blades.
Connecting to the mains (230 Volts, A.C., 50 Hz)
The mower operates from any normal household mains
supply, provided with a 10 Amps. fuse.
Note: Use a residual current device (RCD) rated for a
residual current not greater than 30 mA.
Starting (fig. B3/B4)
Switch on motor with mowerplaced on level and firm ground,
not in high grass - alternatively tilt slightly.
Switch-on motor (fig. B4)
1. Depress button and hold (1).
2. Lift up bar and release button (2).
Switch-off motor (fig. B4)
Release bar (2).
Mowing (fig. B5)
Always let cable trail on the cut side of the lawn. Cable
guidance: Place the cable firmly off the lawn or on the already
cur side of the lawn when starting to mow.
Emptying of Grassbox Esprit 34/36 E
The grassbox is full and should be emptied as soon as grass
clippings remain uncollected on the ground behind your mower.
Note: Disconnect electricity by unplugging cable at the socket-
before proceeding
