638034
11
Verklein
Vergroot
Pagina terug
1/31
Pagina verder
5. Concept 43/47 BAi
Turn ignition key (B8, 4) until engine starts, then release key. Otherwise: Pull starter handle return slowly by hand (B9).
Concept 43 BPP / 43/47 BA
Pull starter handle return slowly by hand (B9).
6. Concept 43/47 BA/BAi
Drive on: Lift drive (B8, 5).
Set speed (Concept 47 BA/BAi): 1st gear – position (B8, 6) slow; 2nd gear – position (B8, 7 fast
7.
OECO position: bring forward gas lever (B5, 2) slightly above the OECO position and afterwards without manipulation of the red notch
button
pull back
to the OECO stop (B5, 1)
8. Concept 43/47 BA/BAi
Drive off: Release drive handle (5).
9. Engine stop: Release safety grip (B7/B8, 3).
• Press primer if the engine does not start in cold weather.
• If the engine has failed because of a lack of fuel, refill fuel. Press primer three times.
Mowing (fig. B10)
Always mow using throttle lever setting OECO or Power.
Mow with throttle lever on „Betrieb“ position. Start engine with mower placed on level and firm ground. Turn Mower on lawn area
already mown. Do not leave mower standing with engine running for longer than absolutely necessary.
Empty catcher bag (fig. B11)
Only when mower is stionary and rotating blade has come to complete standstill.
Level indicator: the flap is lowered if the catcher bag is full (see illus.). Clean the apertures under the level indicator regularly
using a hand brush in order to ensure correct function.
Disconnect spark plug cap and starter key (with electric-start-models) before proceeding!
Clean mower thoroughly after each mowing with cloth or brush (fig. W1/W2).
Do not spray with water. Keep mower in a dry room.
Change oil only
While engine is warm and fuel tank empty.
Change oil after 5 working hours for the first time. After every 25 working hours from then onwards and at the end of the mowing season.
More frequently if working under extreme and dusty conditions. Remove oil filling cap, tilt machine slowly to side and allow oil to drain from
the crankcase
.
Cleaning of Spark Plug
Check and clean and regulary, as required (0,76 mm).
Cleaning of air filter
See the operating instructions of the motor manufacturer (enclosed).
Cleaning operations and blade change (fig. W1)
Tilt the mower towards rear for cleaning operations and blade change: Detach spark plug cable. Fold upper part of handle forwards
(avoid damage to Bowden cables).
Change of Cutter blades (Abb. W3)
Disconnect spark plug cap and starter key (with electric-start-models) before proceeding!
Change of blades only be carried out by an approved service station.
Gloves should be worn at all times when working on the blade. Remove ignition key and spark plug lead when working on the
blade.
Damaged blades should always be replaced in pairs to ensure even balance.
Winter storage
• Drain fuel tank.
• Drain carburettor: therefore start engine, keep it runninug until it automaticalli switches off.
• Clean the whole machine thoroughly
• Change oil, 4-stroke engine.
• Prepare engine for winter storage as follows:
- Remove spark plug. Poor one spoon full of engine oil into spark plug hole. Pull starter rope slowly to distribute oil evenly inside
cylinder.
- Replace spark plug but do not connect spark plug lead.
- Pull starter rope until resistance is felt (valves are now closed)
• Store mower in a cool and dry place. We recommend: Have your mower thoroughly checked once a year by approved Service Agent.
Adjusting the clutch Bowden cable - Concept 43/47 BA/BAi (fig. W4)
Lift the drive bar (1) approx. 2 cm and hold. Loosen counternut (2) and turn adjusting screw (3) anticlockwise until the drive wheels block
when the mower is pulled backwards. Tighten counternut (2) firmly.
Charging the battery - Concept 43/47 BAi
The motor has a built-in charging unit. Therefore, the battery is constantly recharged, as in an automobile.
Separate charging unit (accessory) - Concept 43/47 BAi
SLG-S, order no. 6150 070
Operating
Maintenance
Disposal - Concept 43/47 BAi
Batteries contain lead and must be disposed of in the correct manner. Have defective batteries disposed of by
a specialist workshop. Batteries must be removed from the unit before scrapping (disposal).
11
11

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw WOLF-Garten Concept 47 BAi bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van WOLF-Garten Concept 47 BAi in de taal/talen: Nederlands, Duits, Engels, Frans, Italiaans, Deens, Zweeds, Noors als bijlage per email.

De handleiding is 0,77 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info