540501
3
Verklein
Vergroot
Pagina terug
1/4
Pagina verder
5. Base Adjustments and Shimming
If large windage/elevation corrections have been made using bases or shims, it
will be necessary to have the rings lapped. Consult a quali ed gunsmith if youre
unsure of this procedure.
Note:
Vortex riflescopes come centered from the factory, but you will
need to make some adjustments when initially sighting in your
scope. Many ring and base setups allow you to adjust windage
at the base mount. If possible, use these adjustments for initial
windage change. Though not usually necessary, you can correct
the elevation adjustments using shims under the base mount.
Assuming typical ring spacing of 3.25”, a shim of .001”
will yield 1” at 100 yards, 2” at 200 yards, and so on.
Shim under the front base for more down adjustability and
under the rear base (nearest shooter) for more up adjustability.
6. The Final Range Sight-In
Diamondback riflescopes feature windage/elevation dials that
will allow you to re-index the zero indicator after sight-in without
disturbing your settings. This allows you to quickly return to your
original zero if temporary corrections are used in the field.
7. Resetting Adjustment Dials with Zero Reset
Final sight-in should be done at the range using the exact
ammunition you expect to hunt or shoot with. Set the parallax
adjustment on AO models to match the distance being used for
sight-in. After the scope has been bore-sighted:
A. Fire a shot or two to check that you’re roughly on target. If necessary,
adjust the reticle to put you near the center of the target (see page 7).
B. Next, fire a three-shot group as precisely as possible. Using the center
of this group as a reference, make any necessary correction adjustments
for windage and elevation. Adjust the dials in the direction you wish the
group to move.
C. Fire a final three-shot group to confirm your adjustment and repeat
until you achieve satisfactory results.
Step A Step B Step C
A. Remove outer cap and carefully loosen the central slot head screw
(A1) using a coin or screwdriver while
rmly holding the silver
numbered turret (A2) to prevent
any rotation.
B. Once the screw has been removed, lift the silver turret straight up and
off the scope (B1), again being very careful to prevent any rotation.
C. Position the turret so that the zero mark matches the indicator line
on the base (C1) and carefully push it back down on the base. Replace
and tighten the central screw while firmly holding the turret to
prevent rotation.
D. Replace outer cap and repeat as needed for both dials.
Steps for resetting the dials
Riflescope Installation continued.
Riflescope Maintenance
Your Diamondback riflescope will require very little routine maintenance other than periodically cleaning the exterior lenses. All components of
Vortex riflescopes are permanently lubricated so no additional lubricant should be applied.
Avoid storage in direct sunlight or hot locations since high temperatures
can adversely affect internal lubricants. Do not attempt to disassemble any
components of your ri escope.
When cleaning the lenses, be sure to use products such as the
Vortex Lens Pen or the Fog Free lens cleaning kits that are
designed for use on coated optical lenses. Be sure to blow away
any dust or grit on the lenses prior to wiping the surfaces. Using
your breath, a very small amount of water, or pure alcohol can
help remove oil and dried water spots.
Lens Care
Clean the exterior of the riflescope by wiping with the soft, dry
cleaning cloth provided with the Diamondback riflescope.
Riflescope Body Care
www.vortexoptics.com
3

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Vortex Diamondback Riflescope bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Vortex Diamondback Riflescope in de taal/talen: Engels als bijlage per email.

De handleiding is 0,1 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info