09 Wheels and tyres
09
}}
335
1. Set up the warning triangle and activate
the hazard warning lights if a tyre is being
sealed in a trafficked location.
If the puncture was caused by a nail or
similar, allow this to remain in the tyre. It
helps to seal the hole.
2. Detach the label for maximum permitted
speed (which is fitted on one side of the
compressor) and affix it to the steering
wheel.
WARNING
You should not drive faster than 80 km/h
after the emergency tyre repair kit has
been used. Volvo recommends that you
visit an authorised Volvo workshop for
inspection of the sealed tyre (maximum
driving distance is 200 km). The staff there
can determine whether or not the tyre can
be repaired or if it needs to be replaced.
WARNING
The sealing fluid can irritate the skin. In the
case of contact with skin, wash away the
fluid with soap and water.
3. Check that the switch is in position 0 and
locate the cable and the air hose.
NOTE
Do not break the bottle's seal before use.
The seal is broken automatically when the
bottle is screwed in.
4. Unscrew the orange cap and unscrew the
bottle's stopper.
5. Screw the bottle into its holder.
WARNING
Do not unscrew the bottle, it is equipped
with a reverse catch to prevent leakage.
6.
Remove the valve cover
28
Take the torx wrench (which is fitted in the
foam block behind the panel on the left-
hand side of the cargo area).
Press the torx wrench into the hole.
Prize off the cover using the torx wrench
(A).
Unscrew the valve cap and disconnect
the hose from the compressor to the
valve.
7. Connect the hose from the compressor to
the valve.
28
Only 17" wheel Thia