38
Scope of Delivery
Multimeter with spay-cast rubber protection
Probe converter CLA40 (VC280 only)
9V block battery
2 micro batteries (type AAA, VC280 only)
Safety measuring cable
Operating instructions
Display Indications and Symbols
The symbols and indications are different for each model. This is a summary of all possible symbols and
information of the VC200 series.
REL Delta symbol for relative value measuring (= reference value measuring)
Auto range means “automatic measuring range selection”
Connect terminal Graphic notice to select the required measuring sockets
Low imp.400kΩ Impedance switching in the V measuring range (10 MΩ to 400 kΩ)
OL Overload = the measuring range was exceeded
OFF Switch position “Measuring device off”
Battery replacement symbol; please replace the batteries immediately to avoid
measuring errors!
Symbol for the diode test
Symbol for current measurement with probe sensor
Symbol for the acoustic continuity tester
Symbol for the capacity measuring range
AC Alternating current for voltage and current
DC Direct current for voltage and current
+ Polarity indication for current flow direction (plus pole)
- Polarity indication for current flow direction (minus pole)
mV Millivolt (exp.-3)
V Volt (unit of electric potential difference or voltage)
A Ampere (unit of electric current)
mA Milliampere (exp.-3)
µA Microampere (exp.-6)
Hz Hertz (unit of frequency)
kHz Kilo Hertz (exp.3)
MHz Mega Hertz (exp.6)
Ω Ohm (unit of electric impedance)
kΩ Kilo Ohm (exp.3)
MΩ Mega Ohm (exp.6)
nF Nanofarad (unit of electric capacity, exp.-9, symbol )
µF Microfarad (exp.-6)