Measuring process
- Connect the cable tester and the Remote Terminator with the
cable which is to be tested or for example with the included RJ 45
test cable.
- after pushing the TEST-button the electricity supply of the cable
tester is switched on automatically. The green POWER-LED in the
display glows. At the same time the automatic measurement
process of all single cores is started. as a control the LEDs 1 - 8
glow one after another in quick order. Additionally the cable tester
produces a signal sound.
- after the measuring has been completed successfully the blue
CONNECTED-LED glows as sign that the measured cable is a
1:1 cable without twisted cores. At the same time a signal sound
is produced again, but in a higher frequency. If the 8 cores are all
correctly connected the LEDs 1-8 will glow permanently on the
display. For the control of the measuring result a table is dis-
played below the LED row which shows the respective light dis-
plays fort he different connection cables.
☞
The LED signed with G = Ground will only glow on the IN dis-
play if both RJ 45 plugs are made of material which is electri-
cally conducting and are connected by means of the shiel-
ding within the cable (STP-cable). That is not the case with
unshielded cables (UTP cables)
- after approx. 5 sec. All LEDs on the display will go out and the
cable tester turns off automatically.
23
