6
0478 111 9912 I - EN
Attaching and
detaching the grass
catcher bag
L= Pull ejection flap
upwards.
Attaching:
Attach grass catcher bag
to the appliance with
20= snap-in hooks
19= in the apertures
provided. Guide the
ejection flap manually
downwards onto the
grass catcher bag.
Detaching:
Detach grass catcher
bag from the snap-in
hooks and remove.
Close ejection flap again
manually.
7
Assembling the grass
catcher bag
6= Lay upper part of grass
catcher bag and
7= lower part of grass
catcher bag on a level
surface.
17= Attach tabs
18= of the grass catcher bag
upper part to retaining
pins in the grass catcher
bag lower part.
8= Press the tab
downwards and guide
the retaining plate into
the aperture in the
retaining pin. Press the
retaining plate firmly
inwards.
6
Repeat this procedure for the
installation of the grass catcher
bag on the opposite side.
Close the grass catcher bag
and allow the grass catcher
bag upper part to engage in
the lower part using slight
pressure.
NOTE
Press the retaining plate
inwards until it engages in
the retaining pin.
CAUTION
Risk of injury.
The engine must be
switched off before
attaching and detaching
the grass catcher bag.
Attaching the starter
cable
B= Press and hold motor -
stop lever to release the
engine brake.
C= Slowly pull out starter
cable and
16= fit into cable guide.
4
Adjusting the cutting
height
There are 7 cutting height
adjustment settings ranging
from 25 to 70 mm.
Cutting levels 2 to 6 are
standard.
Level 1 = lowest cutting
height
Level 7 = highest cutting
height
I= The adjustment lever for
front axle height
adjustment is located
next to the left front
wheel.
K= The adjustment lever for
rear axle height
adjustment is located
next to the left rear
wheel.
8
CAUTION
Risk of injury.
The engine must be
switched off before
adjusting the cutting height.
