813784
54
Verklein
Vergroot
Pagina terug
1/72
Pagina verder
54
Clean the surface of the programming unit with a
microfibre cloth.
!Please note
Commercially available domestic cleaning
agents and special cleaning agents for the heat
exchanger (evaporator) can damage the indoor
and outdoor units.
Clean the appliance surfaces only with a damp
cloth.
If necessary, clean the heat exchanger (evap-
orator) fins on the back of the outdoor unit only
with a hand brush with long bristles.
Danger
The sharp edges of the heat exchanger (evapo-
rator) fins can cause cut injuries.
Do not touch the fins on the back of the outdoor
unit.
Danger
The hot or cold fins of the heat exchanger
(evaporator) can cause burn or frostbite injuries.
Do not touch the fins on the back of the outdoor
unit.
!Please note
Commercially available cleaning agents can
damage the surface of the external casing.
Use only mild water-based domestic cleaning
agents.
Do not use substances containing acids or
solvents, such as vinegar-based cleaners,
nitro or synthetic resin solutions, nail varnish
remover, ethyl alcohol, etc.
!Please note
Mechanical impact will scratch the surface of the
external casing.
Wipe the surface with a soft damp cloth only.
Do not use substances that contain abrasive
particles such as polishes, scouring agents,
dirt erasers or scouring pads.
Do not clean the external casing with a pres-
sure washer.
Inspection and maintenance
The inspection and maintenance of a heating system
is prescribed by the German Buildings Energy Act and
the DIN 4755, DVGW-TRGI 2018, DIN 1988-8 and
EN 806 standards.
Regular maintenance ensures trouble-free, energy effi-
cient, environmentally responsible and secure heating
and cooling operation. For this, it is best to arrange an
inspection and maintenance contract with your local
contractor.
Note
Your outdoor unit contains highly flammable refrigerant
of safety group A3. To ensure operational reliability
over the entire service life of the heat pump, there are
special requirements for inspection and maintenance.
A special test of safety equipment is required after
12 years. Please contact your contractor.
DHW cylinder
Standard EN 806-5 specifies that maintenance and
cleaning should be carried out no later than 2 years
after commissioning and as required thereafter.
Only a qualified contractor should clean the inside of
the DHW cylinder and the DHW connections.
If any water treatment equipment (e.g. a sluice or
injection system) is installed in the cold water supply of
the DHW cylinder, ensure this is refilled in good time.
For this, observe the manufacturer's instructions.
Safety valve (DHW cylinder)
The function of the safety valve must be checked
every six months by the user or a contractor through
venting (see valve manufacturer's instructions). The
valve seat may become contaminated.
Water may drip from the safety valve during a heat-up
process. The outlet is open to the atmosphere.
!Please note
Overpressure can cause damage.
Do not close the safety valve.
Maintenance
Cleaning
6199646
54

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Viessmann-VITOCAL-250-A

Zoeken resetten

  • ik wil mijn instalatie op koelen zetten moet ik dat via de display op de binnen unit doen of via de kamer thermostha at Gesteld op 20-7-2024 om 10:17

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Viessmann VITOCAL 250-A bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Viessmann VITOCAL 250-A in de taal/talen: Engels als bijlage per email.

De handleiding is 4.93 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Viessmann VITOCAL 250-A

Viessmann VITOCAL 250-A Gebruiksaanwijzing - Nederlands - 76 pagina's

Viessmann VITOCAL 250-A Gebruiksaanwijzing - Deutsch - 80 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info