Handleiding Vibiemme Vibiemme Double Domobar version 3 (pagina 66 van 74) (Engels)

484572

Verklein

Vergroot

Pagina terug

1/74

Pagina verder

28 While waiting for the descaler to work, remove the reservoir and empty it. Take care not to allow the

reservoir hose to drip or splash descaler. Rinse the reservoir out with clean water, and dry it. Replace the

reservoir and ﬁll to within approximately 1/2 inch (2 cm) of the top with clean water. Replace the pickup

hose into the reservoir.

29 After the required wait time (Step 27), turn the power switch to “Position 0.”

30 Place the vessel under the hot water wand and open the valve. Turn the valve off when no more liquid

comes from the wand. If the vessel becomes full, close the valve, empty it and repeat until no more liquid

comes from the wand.

31 Empty the drip tray if necessary.

32 Turn the power switch to “Position I.” The pump will start and ﬁll the boiler again.

33 When the pump stops, turn the power switch to “Position II.” The PID display should still read “oFF.” Al-

low the pressure in the steam boiler to rise.

34 When pressure has reached the normal operating pressure, turn the power switch to “Position 0.”

35 Place your vessel under the hot water wand and open the valve. Turn the valve off when no more liquid

comes from the wand. If the vessel becomes full, close the valve, empty it and repeat until no more liquid

comes from the wand.

36 FOR PLUMBED MACHINES ONLY -

At this time you can switch back to your plumbed option to make the rest of these steps easier. Remove

the reservoir and replace the screw in the center of the reservoir’s platform. Tighten it until you hear the

“click” of the water-level microswitch, and then at least one more additional turn. Failure to tighten the

screw will keep the machine from operating. You MUST also switch the water source selector lever on

the bottom of the machine back to the plumbed option. The lever should be pointing towards the steam

wand, which is to your left while facing the front of the machine. Rinse, dry and replace the reservoir,

and place the hose back into the reservoir.

CAUTION: Failure to switch the machine back to the plumbed option after tightening the

screw in the center of the reservoir platform will allow the pump to run without a water sup-

ply. This has the potential to damage the pump in a short time. Pump damage caused by run-

ning it dry is not covered by the warranty.

37 Reﬁll the reservoir with clean water if using the reservoir option as the selected water source.

38 Turn the power switch to “Position I.” The steam boiler should go through a reﬁll cycle and stop. When

the pump stops, turn the power switch to “Position II.” Allow the steam boiler to come back up to normal

operating pressure as indicated on the steam boiler’s gauge.

39 Place the vessel under the hot water wand, open the valve and dispense about 6 ounces of water, then

close the valve and discard the dispensed liquid. When the pump stops and the boiler comes back up to pres-

sure, once again dispense about 6 ounces of water through the hot water tap. Rinse and dry the vessel and

dispense another 6 ounces into the vessel. Allow that water to cool sufﬁciently, and if it smells clean and

free of descaling solution, use a clean, dry spoon and sample one or two drops of the water just as you did

for the brew water. If any of the acid taste remains, repeat the six-ounce ﬂush and tasting process until the

water is free of acidic taste.

CAUTION: Most proper de-scaling agents are a form of acid which is food safe, and in highly di-

luted form is relatively safe to consume. Read the label of the product you are using to be sure it is

safe before sampling the discarded water. Sample only a very small amount.

40 When the water from the hot water wand is clean and free from the acidic taste of the cleaner, place a

steaming pitcher under the steam wand and slowly and carefully open the steam wand and dispense steam

for at least ﬁfteen seconds. Close the valve, rinse the pitcher with clean, cool, water. When the steam pres-

sure builds, repeat the steam ﬂush into the empty steaming pitcher. After closing the steam valve, carefully

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Vibiemme Vibiemme Double Domobar version 3 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van Vibiemme Vibiemme Double Domobar version 3

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info