EN - 38 -
Installation instructions and door reversibility
Installation
! Before installation, read the instructions carefully.
! Fit the refrigerator/freezer in stable kitchen units only.
! If necessary, reverse the door according to instructions.
! Check the installation dimensions according to g.C. The position of the joint between
the unit doors must be level with the position of the joint between the appliance doors.
1. See g.A for the necessary attachment components.
2. Insert trim ap
1
into slot and screw by screws
6
. (g.D)
3. Pass the power cord through ventilation shaft and position it so that the appliance could
be easily plugged in once it has been installed. (g.B - g.C)
4. Take out the trim gasket
2
located on the side panel of the appliance and stick it on the
reverse side of the door hinges of the appliance. (g.D - g.E)
5. Raise appliance and slide into the kitchen unit. Push the appliance to the reverse side
of door hinges providing that the trim gasket
2
covers space between appliance and the
kitchen unit.
6. Align front feet with the front surface of the kitchen unit. (g.F)
7. Screw the front feet by using screws
5
. (g.F)
8. Screw the trim ap
1
to the kitchen unit using screws
5
. (g.G)
9. Screw the xing bracket
11
, as leaned to kitchen unit by using screws
5
. Repeat this for
the opposite side. (g.H)
10. Screw guides
3
to the appliance doors with screws
6
. Lean the appliance doors to the
unit door as it is opened at right angle. Slide rails
4
into the guides
3
aligning the groove.
Screw the rails
4
to the unit doors with screws
5
. (g.J)
11. Set 1~2 mm gap on the handle side between the unit itself and the unit doors by adjusting
the guides
3
. This is vital for appliance performance. (g.J)
