KAYAK EQUIPMENT - SUPPLEMENTAL INSTRUCTIONS REQUIRED
If you have purchased a KAYAK ERGOMETER or KAYAK KIT, please locate the separate instruction
sheet packaged with the Kayak Foot Brace (part #VE-K-FB). <RXZLOOQHHGWRLQVWDOOND\DNVSHFL¿F
parts at this point prior to continuing with your assembly.
9
Vasa Ergometer User’s Manual
07/01/11
MONORAIL
if necessary, loosen the
socket set screw with 3/16”
hex key wrench
REAR STANCHION
slide monorail into
front stanchion sleeve
FRONT
ERGOMETER
ASSEMBLY
Figure B
Figure A
hex jam nut
Figure C
insert and tighten
2 1/2” button
head screw and
hex jam nut
tighten socket set
screw with 3/16”
hex key wrench
INSTALLATION TIP
,IWKHµEROWLVGLϞFXOWWRLQVWDOO
press the rear cover in so it provides
more clearance for the 2 1/2” screw
(see photo right). In some cases, it
might be necessary to remove the front
FRYHUÀUVWWRDOORZPRUHURRPWRSXVKLQ
the rear cover.
socket
set screw
THUMB IS PUSHING
COVER IN
PART 1 - Assembly
STEP 6: ATTACH FRONT ERGOMETER ASSEMBLY TO MONORAIL
6.1. Hold the front Ergometer assembly upright in one hand. Lift the front end of the monorail up to the
height of the front stanchion sleeve (on the Ergometer assembly). Insert the monorail into the sleeve
until the holes in the sleeve line up with the holes in the monorail (Figure B).
NOTE: If the monorail will not slide all the way into the front stanchion sleeve, loosen the socket set
screw on the corner of the front Ergometer assembly (Figure A) using the 3/16” hex key allen wrench.
Do not removeWKHVRFNHWVHWVFUHZ-XVWORRVHQHQRXJKVRWKHPRQRUDLOFDQ¿WLQVLGHWKHVOHHYH
6.2. Insert one 2 1/2” button head screw through the sleeve and the monorail (Figure C). Thread and
tighten one hex jam nut (Figure C). Tighten with 5/32” allen wrench and 7/16” wrench.
6.3. Tighten the socket set screw against monorail using the 3/16” allen wrench. This will secure the
monorail to the inside of the sleeve so that it won’t loosen or rattle while in use (Figure C).
