POWXG6305 EN
Copyright © 2020 VARO Page | 5 www.varo.com
▪ Ensure the correct installation of the charging station and boundary wire as instructed.
▪ Periodically inspect the area where the machine is to be used and remove all stones,
sticks, wires, bones, and other foreign objects. Failure to do so can lead to the mower
getting stuck / damaged!
▪ Periodically visually inspect to see that the blades, blade bolts and cutter assembly are not
worn or damaged. Replace worn or damaged blades and bolts in sets to preserve
balance.
▪ On multi-spindle machines, take care as rotating one blade can cause other blades to
rotate.
5.3 Operation
5.3.1 General
▪ Never operate the machine with defective guards, or without safety devices.
▪ Do not put hands or feet near or under rotating parts.
▪ Never pick up or carry an machine while the motor is running.
▪ Remove (or Operate) the on/off switch from the machine
o before clearing a blockage;
o before checking, cleaning or working on the machine;
o after striking a foreign object to inspect the machine for damage;
o if the machine starts to vibrate abnormally, and to check for damage
before restarting.
5.3.2 Additionally when the machine is operating automatically
▪ Do not leave the machine to operate unattended if you know that there are pets, children
or people in the vicinity.
5.3.3 Maintenance and storage
▪ Keep all nuts, bolts, and screws tight to be sure the machine is in safe working condition.
▪ Replace worn or damaged parts for safety.
▪ Ensure that only replacement cutting means of the right type are used.
▪ Ensure that batteries are charged using the correct charger recommended by the
manufacturer. Incorrect use may result in electric shock, overheating or leakage of
corrosive liquid from the battery.
▪ In the event of leakage of electrolyte flush with water/neutralizing agent, seek medical help
if it comes into contact with the eyes, etc.
▪ Servicing of the machine should be according to manufacturers’ instructions.
5.3.4 Recommendations
▪ Connect the machine and/or its peripherals only to a supply circuit protected by a residual
current device (RCD) with a tripping current of not more than 30 mA.
▪ Avoid using the machine and its peripherals in bad weather conditions especially when
there is a risk of lightning.
▪ Read all safety warnings and all instructions. Failure to follow all warnings and instructions
may result in electric shock, fire and/or serious injury. Save all instructions for future
reference. The term "power tool" in the warnings refers to your mains operated (corded)
power tool or battery operated (cordless) power tool.
