POWDPG75270 EN
Copyright © 2021 VARO P a g e | 8 www.varo.com
Those 3 LED might show the status of the capacity level of the battery:
3 LED’s are lit: Battery fully charged.
2 LED’s are lit: Battery 60% charged.
1 LED is lit: Battery almost discharged.
9 ASSEMBLY
WARNING: Switch off and remove battery from machine before adjusting or
cleaning!
WARNING: Always wear shoulder strap when operating machine.
9.1 Assembly of the tubes (Fig. 4)
▪ Insert the upper suction tube (2) into the cordless leaf blower body ensuring that it fits
correctly and is pushed fully in.
▪ Secure it on both sides of the suction/blower housing with the two 12 mm screws
provided.
▪ then Insert the upper blowing tube (3) into the cordless leaf blower body ensuring that it
fits correctly and is pushed fully in.
▪ Secure it with the 18 mm screw provided.
▪ Insert both upper suction (2) & upper blower tube (3) into the lower suction/blower tube
(1).
▪ Ensure that it is fitted correctly and pushed fully in.
▪ Secure both with the two 18 mm screws provided.
9.2 Fixing the wheels
▪ Slide the wheel set onto the lower tube of the leaf blower as shown in Fig. 5.
▪ Place the wheels in the desired position and fasten them with the handle screw (Fig. 6).
9.3 Fitting the adjustable handle
▪ Connect the adjustable handle to into the cordless leaf blower body (Fig. 7).
▪ Adjust the handle position at wish.
▪ tighten the knob screw (Fig. 8).
9.4 Fitting the collection bag (Fig. 9 – Fig. 10)
▪ Before fitting the debris collection bag (9) ensure that the Vacuum/Blow selector lever (8)
operates smoothly and that it is not obstructed by debris from previous use.
▪ Attach the collection bag (9) with its connector to the discharge opening at the base of the
machine as shown in (Fig. 9 to 10).
▪ Then attach the front of the debris collection bag to the underside of the suction-blower
tube using the clip fitted to the debris collection bag.
9.5 Fitting the output adaptor (Fig. 11)
▪ If you use the machine as a blower, you can fit the output adaptor instead of the collection
bag. Proceed in the same way as described under „Fitting the collection bag“.
9.6 Fitting the shoulder strap (Fig. 12)
▪ The cordless leaf blower is equipped with a shoulder strap which is attached to the
housing as shown in Fig. 12.
▪ With the shoulder strap, the cordless leaf blower can be carried in a comfortable position
for the operator to reduce fatigue.
