POWDP50300 EN
Copyright © 2021 VARO P a g e | 8 www.varo.com
9 FEATURES
Your finishing sander is equipped with TPR soft grip and protective parts. TPR (Thermoplastic
rubber) is elastic, chock absorbing and environmental friendly (recyclable).
10 OPERATING INSTRUCTIONS
Before attempting to use your sander be sure to familiarize yourself with all its operating
features and safety requirements.
Warning! The battery should always be removed from the machine when
assembling parts, marking adjustments, cleaning or when the tool is not in
use. Disconnecting the battery will prevent accidental starting that could
cause serious injury.
Do not sand plaster surfaces, (WARNING: In this case your guarantee
becomes void) this may clog the motor (brushes, ball bearings, ...).
10.1 Sanding
▪ Hold the sander in front and away from you, keeping it clear of the work piece.
▪ Start the sander
▪ Let the motor build up to speed then gradually lower it on to the work with a slight forward
movement .
▪ Move the sander slowly over the work piece using forward and back or side to side
strokes.
▪ Upon completion of the sanding operation remove the sander from the work piece before
turning it off.
10.2 Switching On-off (Fig. 4)
Connect the battery pack (6) to the power tool by pushing the release button (7). The tool is
switched “On” by the ON/OFF switch (2) located on top of the tool housing.
▪ Switch on: push the ON/OFF switch button (2) to the “I” position.
▪ Switch off: push the ON/OFF switch button (2) to the “O” position.
10.3 Attaching the sandpaper
Attaching Non-self-adhesive sandpaper (not included) (Fig. 5).
▪ Open the paper clamps (5).
▪ Take sanding paper of the required grain size and place it on the sanding pad.
▪ Make sure that the perforation in the paper corresponds with those on the sanding pad.
▪ Fold the sanding paper at both ends around the edges of the sanding pad.
▪ Close the paper clamps one by one.
▪ Make sure that the ends of the sanding paper are clamped.
▪ The sanding paper must be fitted firmly on the sanding pad and should not come loose.
Attaching self-adhesive sandpaper (Fig. 6).
▪ Select a sandpaper with the appropriate grit size for the task.
▪ Position the sandpaper so that its holes are aligned with those on the sanding pad (3).
▪ Press the sandpaper onto the sanding pad and check it is secure.
▪ To remove the sanding paper carefully peel the sanding paper away from the sanding
pad.
WARNING: When removing the sanding paper, follow the above procedure
in reverse order.
