Handleiding Varde Fuego (pagina 14 van 22) (Engels)

813312

Verklein

Vergroot

Pagina terug

1/22

Pagina verder

How to light and stoke a fire

The first time you light up the stove, the enamel will temper and give off some smoke and a

slightly burnt smell. We recommend that you leave doors and windows open, as airing the room

will make the smell disappear.

This tempering softens the enamel, making it susceptible to damage. Therefore exercise caution

and avoid touching the enamel. We also recommend opening the door to the stove at regular

intervals during the first couple of hours to prevent the rope seal from sticking to the enamel.

Never use highly flammable liquids such as methylated spirit or petrol for lighting up!

We recommend using ‘top-down’ lighting, where you light the wood at the top of the combustion

chamber and not at the bottom. This is the most environmentally friendly method to light a fire.

The method will also help keep the glass clean. Place four small logs in a cross on the bottom

plate of the combustion chamber (approx. 1.5 – 2 kg) with a small distance between each log.

Place 8 – 12 smaller sticks (0.5 – 1 kg) in a cross on top of the logs, and 2 – 3 firelighters at the

top and in between the sticks.

A thin layer of ash at the bottom of the stove makes it easier to light the fire.

Before lighting the stove, open the shaking grate by pulling the small lever under the combus-

tion chamber completely towards the right. Pull the lever underneath to the right as well to allow

the ignition air to enter and pull the combustion air damper towards the right until it is com-

pletely open.

Once the fire burns, remember to close the ignition air vent and shaking grate again. Otherwise,

the stove and chimney might become overheated, which would invalidate the warranty.

Once the kindling has reduced to embers, we recommend opening the door slightly for a couple

of seconds to neutralise the negative pressure in the combustion chamber before opening the

door completely.

Place 3 – 4 logs in a cross on top of the embers (approx. 2 kg) and close the door again. To

make sure the wood ignites quickly, we recommend briefly opening the ignition air vent and

make sure you remember to close it again once the fire gets going. You can then adjust the

combustion air according to your heating requirements.

Take care not to shut off the air supply completely, otherwise the fire will die. The fire should

always burn bright and clear.

In most instances, however, you will have to identify the best combustion air settings your-

self, as the height and draught of your chimney as well as the quality of the firewood are deci-

sive factors in determining the best settings for your particular stove.

If the nominal heat output of your stove is too high compared to your heating requirements, you

can reduce the output as follows:

- Stoke a smaller amount of wood than usual, for example 1.2 – 1.3 kg, preferably consisting of

3 – 4 smaller pieces of wood. Apply full air to ignite the wood properly before reducing the com-

bustion air, perhaps down to approx. 60%. Be careful not to reduce the air supply to the point

that the fire dies. The fire should always burn bright and clear.

With this method it is possible, depending on the chimney, wood quality, etc., to reduce the

stove’s heat output from a nominal 5 kW down to perhaps 3 – 3.5 kW.

Please be aware that it can lead to poor combustion if you reduce the combustion air too much,

resulting in a lower efficiency and increased emission levels (increased pollution).

You may wonder why your stove is fitted with a gap in the rear vermiculite plate in the combus-

tion chamber, with small holes through the back steel plate, but these holes are an important

part of the combustion system. We refer to these air ducts as the ‘tertiary air’. They are an

important part of a clean-burning stove.

When refilling the stove with wood, we recommend opening the stove door once only embers

are left in the combustion chamber. Opening the door while flames are still burning and produc-

ing smoke and gas might cause smoke to escape into the room.

If you have problems lighting or operating the stove, see the section on Troubleshooting.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Varde Fuego Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Andere handleiding(en) van Varde Fuego

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info