8
Important!
Before you install and use your new Varde
stove for the first time, w e recommend
that you first spend a couple of minutes reading
this Installation and User Manual.
Inspection of the installation
It is extremely important that the installation is
inspected by an authorised chimney inspector
before the stove is used for the first time.
Applicable regulations
The installation must comply with all local
regulations, including those that refer to
national and European standards. Seek
advice and guidance from the dealer from
which you bought the stove or from a
professional installation technician.
NB: All Varde wood-burning stoves are
closed fires.
This Varde stove is approved in accordance
with:
European Standard DS/EN 13240/PrEN 16510
German Stufe 2 and Norwegian NS and §15 for
Austria and is accordingly certified as having
eco-friendly combustion properties.
The stoves are designed for intermittent
combustion and are also designed for
chimneys with several stoves connected.
Professional installation
We recommend that you seek advice from the
dealer you purchased the stove from or from
another competent installation technician, as
there can be specific details that must be
taken into consideration with the installation.
Duty to report
The local chimney inspector has a duty to report.
Before the installation is carried out, the stove must be stored in a dry place at room temper-
ature. The stove does not tolerate moisture.
Please note that your existing chimney may not necessarily be efficient enough for a new,
modern wood-burning stove.
EU Declaration of Conformity. MANUFACTURER
Name: Varde Ovne A/S
Address Pottermagervej 1, 7100 Vejle, Denmark
Fireplace Inspection
Name: RRF
Address Im Lopperfeld 34b, 46047 Oberhausen, Germany
Product Varde
Product type Aura 1, 11, 2, 3 and 3 Stone
Type designation Wood-burning stove, suitable for intermittent use
Standard Construction product (89/106/EC/) standard used
EN 13240
Application Heating of homes
Fuel Wood
Special conditions None
CE marking
Issued 2017
Nominal output 5.0 kW
Type of fuel Wood
Flue gas temperature 265°C
Efficiency 81%
CO emissions 0.10%
Jan Meldgaard
CEO
Varde Ovne
17
Vermiculite
The panels in the combustion chamber are know n as vermiculite panels and they
become worn over time. The smoke guide plate also becomes worn.
You only need to replace the panels if the crack is more than about ½ cm wide.
Vermiculite
A special fireproof material made of compressed stone granulate, which looks like fibreboard.
The panels are insulating and ensure that the stove does not wear out. Vermiculite panels are
not covered by the warranty.
Vermiculite is a very porous material and must be handled with care.
Only original spare parts from Varde Ovne A/S may be used.
1. Smoke guide plate
2. Left side plate
3. Right side plate
4. Rear plate
How to replace the vermiculite cladding
1. Lift the smoke guide plate/top plate gently and tilt the side up; it can be edged out
diagonally.
2. Lift the left side plate gently and take out.
3. Lift the right side plate gently and take out.
4. Remove the bar on the shaker grate; do this by removing the ash pan and lifting the
rotating section of the cast iron base on the left side. You can then remove the bar from the
shaker grate through the hole.
5. Push the cast iron base right to the back of the stove and lift at the front, allowing the rear
plate to slide free.
To fit, repeat the procedure in reverse.
1
2 3
4
