Using the bab
Power on or off the baby unit
• Press .PO light turns on.
• Press and hold until the PO light
turns off.
Power on or off the parent unit
• Press and hold until the PO
light turns on.
• Press and hold until the PO
light turns off.
Adjust speaker volume
The sLevel 3
on th
preferre
• Press to decrease the volume, and to
increase the volume.
• If you c or when t
volu
set
T
• Press repeatedly until the volume
reaches the minimum.
NOTE
• Whe
ind
the b
• T rep
your d
General pr
To keep this product working well and looking good,
follow these guidelines:
• Avoid placing it near heating appliances and
devices that generate electrical noise (for
example, motors or fluorescent lamps).
• DO NOT expose it to direct sunlight or moisture.
• Avoid dropping the product or treating it roughly.
• Clean with a soft damp cloth.
• DO NOT immerse the parent unit and the baby
unit in water and do not clean them under running
water
• DO NOT use cleaning spray or liquid cleaners.
• Make sure the baby unit and parent unit are dry
before you connect them to the mains again.
Storage
When you are not going to use the baby monitor for
some time, remove the 2 rechargeable batteries (Ni
Mh Ce
Store the parent unit, the baby unit and the adaptors
(DC 6V; 450m
Operating range
The baby
ov
locations of the bab
and the la
out of range
and enter searching mode
mov
/ 2 metres).
Frequently
Below are
the baby
Why doesn’t
the PO
light on the
baby unit turn
on when I
switch on the
units?
P
connected to the power supply
Con
sup
Why doesn’t
the PO
/ LINK light
on the parent
unit turn on
when I switch
on the units?
P
unit is empty and the parent unit is
not connected to power supply
Make sure y
rechargeable batteries provided,
and then connect the parent unit
to power supply to charge the
battery
and establishes connection with
the baby unit.
Why does the
baby monitor
not respond
normally?
T
listed) for common cure:
1. Make sure that both baby
uni
Disconnect the power from the
baby unit and the parent unit.
2. Remove the batteries from the
parent unit.
3. Con
power s
uni
4. Con
power s
t
prov
on.
5. Wait for the parent unit to
synchronize with the b
Allow up to one minute for this
to take place.
6. Pres or to adj
sp
unit.
Why does the
baby monitor
produce a
feedbac
The units may be too close to
each other
unit and the baby unit at least
6.5 feet / 2 metres a
other
Why don’t I
hear a sound/
Why can’t I
hear my bab
cry?
Make sure that both bab
parent unit are on.
visual sound indicators light up
but there is no sound, then y
may ha
set it to a lower le
volume to a higher le
If the visual sound indicators do
not light up
any sound, it is because the bab
sound is too low f
to detect.
the baby unit at least 6.5 f
metres aw
Why does the
parent unit
beep?
The parent unit beeps
ev
unit is out of
parent unit closer to
unit (but
metres).
If the parent unit is powered b
batteries, the parent unit beeps
twice ev
light flashes in red when the
battery is low
unit to power supply to charge the
battery
Why does
the parent
unit light
flash?
If the parent unit is powered b
batteries, the parent unit beeps
twice ev
light flashes in red when the
battery is low
unit to the power supply to charge
the battery
Why can’t I
establish a
connection?
Why is the
connection
lost ev
now and
then?
are there
sound
interruptions?
The baby unit ma
Mov
baby unit (b
6.5 feet / 2 metres).
Other electronic products may
cause interference with y
monitor
monitor as far a
electronic devices as possib
Impor
The a
baby u
Whe
sho
ele
1. Follow all warnings and instructions marked on the
product.
2. Adult setup is required.
3. CAU D
ab
4. Thi
the i
of the parent or
operating, and therefore y
continue working proper
Fur
us
super
5. D
nea
6. CAUTION: Use only the battery provided. There may be
a risk of explosion if a wrong type of battery is used for
the parent unit. The battery cannot be subjected to high
or low extreme temperature and low air pressure at high
altitude during use, storage or transportation. Disposal of
battery into fire or a hot oven, or mechanically crushing
or cutting or the battery can result in an explosion.
Leaving the battery in an extremely high temperature
surrounding environment can result in an explosion or
the leakage of flammable liquid of gas. Battery subjected
to extremely low air pressure may result in an explosion
or the leakage of flammable liquid or gas. Dispose of
used batteries according to the instructions.
7. Use only the ada
Incorrect ada
damage the product.
8. Us
Use o
sup
T
Mo
S003
Use onl
2 x 1
Cor
9. The power ad
oriented in a vertical or floor mount position. The
prongs are not designed to hold the plug in place
if it is plugged into a ceiling, under-the-table or
cabinet outlet.
10 For pluggable equipment, the socket-outlet sho
be installed near the equipment and sho
easily accessible.
11 Unplug this product from the wall outlet before
cleaning. Do not use liquid or aerosol cleaners. Use a
damp cloth for cleaning.
12 Do not cut off the power ad
with other plugs, as this causes a hazardous
situation.
13 Do not allow anything to rest on the power cords.
Do not install this product where the cords may be
walked on or crim
14 This product should be operated only from the type
of power source indicated on the marking label. If
you are not sure of the type of power supply in your
home, consult your dealer or local power company.
15 Do not overload wall outlets or use an extension cord.
16 Do not place this product on an unstable table, shelf,
stand or other unstable surfaces.
17. This product should not be placed in any area
where proper ventilation is not provided. Slots and
openings in the back or bottom of this product
are provided for ventilation. To protect them from
overheating, these openings must not be blocked
by placing the product on a soft surface such as
a bed, sofa or rug. This product should never be
placed near or over a radiator or heat sou
18 Never push objects of any kind into this product
through the slots because they may touch
dangerous voltage points or create a short circuit.
Never spill liquid of any kind on the product.
19 To reduce the risk of electric shock, do not
disassemble this product, but take it to an
authorized service facility. Opening or removing
parts of the product other than specified access
doors may expose you to dangerous voltages
or other risks. Incorrect reassembling can cause
electric shock when the product is subsequently
used.
20. You should test the sound reception every time you
turn on the units or move one of the components.
2 Periodically examine all components for damage.
22. There i
ce
coT
make s
pur
powe
powe
som
23. Children should be supervised to ensure that they
do not play with the product.
24. The product is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
SAVE THESE INSTRUCTIONS
Cautions
1. Use and store the product at a temperature
between 0o C and 4o C.
2. Do not expose the product to extreme cold, heat
or direct sunlight. Do not put the product close to a
heating source.
3. Batteries should not be exposed to excessive heat
such as bright sunshine or fire.
4. M
co
at le
avoid a
5. Never place the baby unit(s) inside the baby’s c
playpen. Never cover the baby unit(s) or parent unit
with anything such as a towel or a blanket.
6.
with your baby monitor. Try installing your baby
monitor as far away from these electronic devices
as possible: wireless routers, radios, cellular
telephones, intercoms, room monitors, televisions,
personal computers, kitchen appliances and
cordless telephones.
Customer service and
product warranty
I
Plea
pro
Custome
Plea
on 0
(
hap
Technical specications
Frequency
control
Crystal controlled PLL synthesizer
Transmit
frequency
Baby unit: 1
Parent unit: 1
Ma
tra
Channels 10
Nominal
effective
range
Actual operating range may
vary according to environmental
conditions at the time of use.
Power
requirements
Baby u
Out
Parent u
Out
Parent u
1
Manufacturer
23/
57 Tin
Imp
Nap
Oxon, OX
Credits
Th
For
Th
and i
T i k n d
and i
Th
use
Disposal of batteries and
product
The c
on pr
res
mus
waste a
that c
envir
The c
Pb, wher
the b
sp
cad
Bat
The s
pro
af
Hel
dis
responsibly
Declaration of conformity
This product is intended for use within Europe and
UK.
This equipment complies with the essential
requirements to EU’
(2014/53/EU) and the UK’
on radio systems and telecommunication equipment.
VT
this Audio Monitor DM1111 is in compliance with the
essential requirements and other relev
of EU’
UK’
The Declaration of Conf
av
Sp
© 2021 VTech T
All rights reserved. 07
This warranty is valid for the UK and Ireland only. For products purchased outside
the UK and Ireland , please contact your local distributor or place of purchase.
P
R
O
D
U
C
T
W
A
R
R
A
N
T
Y
ONE
YEAR PRODUCT
Thank you for choosing this quality product from VTech.
1.The product detailed above is covered by a one year warranty from the date of purchase,
against any defects in materials or workmanship.
2.The product may be returned to the place of purchase. Alternatively the product can be
returned to VTElectronics Europe Plc (see address below), with proof of purchase,
without proof of purchase no replacement will be provided.
3.VTPlc will examine the product and if it is found to be defective
due to faulty materials or workmanship, will replace the product at their discretion.
4.If the product covered by this warranty is damaged due to misuse, modification or
unauthoriz ed repair, or because of faulty batteries, battery discharge or incorrect
electrical connections, then this warranty becomes void.
5.This warranty is personal to the original purchaser and is not transferable.
6.Breakages to the LCD screen are not covered by the warranty.
7.Products returned to VTPlc , should be sent to the
below and carefully to avoid damage in transit . Please do not include batteries or
adaptors . Please include details of the fault together with your name and address,
contact phone number and/or email address.
8.To keep an online record of your warranty, please register your product online at
www.vtech.co.uk/clubvtech
VT ech Electronics Europe Plc , c/o XPO Logistics, Warehouse 350, Cat & Fiddle Lane,
West Hallam, DE7 6HE
THIS WARRANTY IS OFFERED AS AN EXTRA BENEFIT AND DOES NOT AFFECT
CONSUMERS’
PRODUCT REGISTRATION
Visit www.vtech.co.uk/clubvtech/login
to register your VT
By joining the VT
find out about news and events, seek expert advice for parents
and let your kids play fun learning games and activities.
