ON/OFF Button
Press the On/Off button when you are ready to begin your therapy session.
The VQ
TM
Vector always turns on with 0 intensity. Pressing the On/Off button
at any time during the therapy session will immediately stop stimulation
and turn the device off. If you press and hold the On/Off button you will see
your serial # displayed on the screen.
Display Button
Press this button to display each of the parameters for the preset. There will
be at least two screens of information for each preset. Additional screens
may be made available by your clinician.
Increase Button
Pressing and releasing this button increases the intensity of the stimulation.
The display will show you in milliamps how high your intensity is set. The
range is from 0 to 50 milliamps in 0.5 milliamp increments.
Decrease Button
Pressing and releasing, or pressing and holding this button decreases the
intensity of the stimulation. Usually when your treatment is over the unit
will turn off automatically. It is not necessary to decrease the intensity to
turn the unit off.
Next Button
Used by your clinician to set up the unit.
Save Button
Used by your clinician to set up the unit.
Vector W Button
Pressing this button during treatment will rotate the stimulation pattern to
the left so that you will feel the stimulation more intensely in the left side
of your treatment area and less in the right side. Pressing and holding this
button will make the stimulation pattern sweep from side to side every
60 seconds.
Controls and Features
7