en
7
To ensure good washing results, the
dishwasher requires soft water, i.e.
containing low amounts of lime, otherwise
white limescale will be deposited on the
utensils and inner container.
Tap water above 9° Clarke (from set value
•:‹‚) must be softened. The water is
softened with salt (regeneration salt) in the
water softening system of the dishwasher.
The setting and therefore the required
amount of salt depends on the degree of
hardness of your tap water (see table).
Setting
The amount of salt dispensed can be
set in 4 stages
depending on the hardness of your water.
Accordingly 0, 1, 2 or 3 displays are lit
(see table).
– Find out about the hardness
value of your tap water. Your water
utility company will help you with this.
– Setting can be found in the water
hardness table.
– Open the door.
– Hold down the programme button +
and switch on the main switch (,
then release both buttons.
The display P flashes
and the buttons # and + light up.
(Hardness value has been set to 2
at the factory.)
To change the setting:
– Press programme button +.
Each time the button is pressed,
the value increases by one setting.
You can select a set value between 0
and 3 according
to the hardness of your water.
When the buttons #, + and 3
light up, the maximum hardness value
has been reached. When the button
is pressed again, the lamps go out and
the set hardness value is set to 0.
–Switchoffthemain switch(.
The chosen setting has now been
stored.
– Close the door.
Water hardness table
Water softening system
