619719
4
Verklein
Vergroot
Pagina terug
1/7
Pagina verder
1
ELECTRIC BICYCLE
USER MANUAL
2
Main Technical Parameters and Specification
E BIKE URBAN
Weight: 23 kg
Wheel size: 20”
Maximum speed: 25 km/h
Range: Up to 45km (with pedal assist)
Battery
Type: lithium
Voltage: 36V
Capacity: 9Ah
Motor
250W 36V
Charger
Input Voltage:
AC100V-240V 50HZ-60HZ
Output: 42V/1.8A
Charging Time: 5~8h
3
Please read! General maintenance and safety advice
1) Users of E BIKE URBAN should observe local road and traffic regulations for
standard bicycles in force in the country of use at all times.
2) Please read this manual before using E BIKE URBAN
3) Ensure that the power switch on the handlebar is
switched off when the E BIKE is not use.
4) The seat post should not be raised beyond the safety line
indicated. Please note that the tightening torque of the
saddle’s grip nut and posts clamping bolt is 18N.m.
5) The handlebar post should not be raised beyond the
safety line indicated. Please note that the tightening torque of
screw rod for handle and the torque of horizontal road fixing
bolt is 18N.m.
6) Always check that the front and rear brakes are working
correctly and that the tyre pressures are correct before riding
E BIKE URBAN
7) The tightening torques of the front and the rear hub nuts are 18N.m and 30N.m
respectively.
8) Do not wash your E BIKE URBAN with the battery charger connected to the
battery whilst charging to prevent the possibility of electric shocks.
9) Do not submerge the battery in water. Do not ride your E BIKE through water
deeper than 8” or 20 cm.
10) Do not tamper with the electrical control unit on your E BIKE URBAN. This
could endanger the rider and will invalidate the warranty.
11) Approximately every 6 months it is important to clean and lubricate the front,
back and middle axles, flywheel, and front forks plus other moving parts with a
good quality grease.
12)
(insert seat post until safety line can no longer be seen)
Safety line
Insert
Insert
Safety line
4
Quick start guide
l Charge the battery following the battery charging
instructions below.
l Adjust the height of the seat and handlebars to your
preferred position ensuring that you do not exceed
the height safety line indicated on the seat post and
handlebar post.
l Check that the tyre’s have been inflated to the correct pressure and that the front
and rear brakes operate correctly. Please refer to the section below explaining
how to adjust the brakes as necessary.
l Install the battery in to the frame of the bike. Insert the key into the lock, press
down the upper cover of the battery box, turn the key clockwise about 180
degrees and remove key.
l Next power on the P.A.S. (Pedal Assist System) A red LED will indicate that the
device is powered on.
l Use the + and – buttons to select the amount of pedal assistance required.
The battery level indicator will inform you of how much power is left in the
battery.
l Your E BIKE URBAN is now ready to use. Ride your E BIKE as you would a
normal bicycle but as you pedal you will feel the bikes motor providing gentle
assistance depending on the level of pedal assistance set.
l Please note: Your E BIKE URBAN has a range of up to 45km. Please note that
this range will be determined by the amount and severity of slope on your route,
the weight of the rider, correct tyre pressure, opposing wind and the amount of
pedal operation by the rider themselves.
l To conserve battery power please ensure you switch the battery off when not in
use.
Driving without pedal assistance.
l It is possible to ride your E BIKE URBAN like a normal bike. To deactivate the
PAS simply power it off and switch the battery off using the key.
X
5
Battery and charger safety advice
l Please save this manual as it contains important operating and safety information
about the battery and charger.
l Please read this manual before using the battery and charger, including the
warning label on the charger and battery pack.
l Do not expose the battery charger to rainy or wet conditions or operate in
temperatures below 0 or above 35 as this may damage the charger.
l Only use the charger to supplied to charge the battery supplied with your E BIKE
URBAN. Do not use the charger supplied to charge any other battery.
l Do not attempt to lengthen the power cable supplied with the charger or to open
and tamper with the charger in any way.
l Do not store the battery in an environment which could exceed 50 - in the car in
summer for example, as it may adversely affect the performance of the battery.
l Do not throw the battery pack into fire, as there is a risk of explosion.
l Only Operate the charger according to the INPUT and OUTPUT values marked
on the rating label.
l Ensure that the battery charger is well ventilated and do not cover during
charging.
l Store the battery in a safe and dry place when not in use. To maintain battery
quality during long periods of inactivity, fully charge the battery every 2 to 3
months.
Charging the battery.
Please note: when charging the battery for the first time, please charge for 10 hours to
ensure that the battery is fully charged and conditioned.
l Connect the charger to the battery.
l Connect the power plug of the charger to an appropriate AC outlet socket. The red
LED indicator will illuminate to show that the charger is operating correctly.
l When the battery is fully charged the LED will turn from red to green.
l The battery will take up to 8 hours to fully charge depending on much charge was
left in the battery before you began charging the battery.
6
1. Brake arm
2.
Brake block
3.
Spring adjusting
screw
4.
Brak
ing cable seat
5.
Braking cable
Adjusting the brakes
Examine the brakes on your E BIKE regularly to ensure they are working
correctly as follows:
l Adjusting the front brake.
1.1 Check the right brake leaver as per the picture.
Full braking should be reached when the leaver reaches
the halfway point indicated by the ‘X
1.2 Loosen the screw on the
braking cable seat as per the
picture.. Then tighten or loosen
the braking cable, enabling the
average stroke between the two
brake blocks and the rims so it is
approximate 1.5mm to 2mm.
l Adjusting the rear brake.
2.1 Check the left brake leaver operates as per the right following the instructions
above.
2.2 Adjust the inter-enlarge servo brake as per the picture bellow.
u Firstly, adjust the brake to meet the requirement in 1.1 and loosen the brake. Then,
use the screwdriver to adjust the adjusting screw to touch the servo block. Tighten the
brake handle to adjust the screw to have a gap (about 2mm) with the block. Continue
to adjust the gap to be half of the original (about 1mm).
Keep on adjusting till the rear wheel runs agilely and the brake is effective.
Please note: Pay attention to the wear of the brake rubber-block. Please replace when
worn to ensure that the brakes
on your E BIKE work
effectively.
1 adjusting screw
2 Braking cable
seat
3 Braking cable
4 fine adjustment
screw
X
7
Troubleshooting
Trouble Description
Causes
Troubleshooting Methods
The power LED is not
illuminated and the
bicycle doesn’t start
when the switch is
turned on.
Poor contact between the
electrodes of the battery
box or battery seat.
Check for dirt on the electrodes
of the battery box or seat, and
remove it.
The motor runs
immediately once the E
BIKE is powered on.
(Note: immediately
power off the switch to
avoid accident.)
l The speed-adjusting
handle is not reset.
l The controller is
damaged.
l Check whether the
speed-adjusting handle is
operating correctly and reset
if necessary
l
E BIKE is slow when
riding or pedal assist
range is short
l The tyres are not
inflated enough.
l Frequent starts, hills
and slopes on route or
riding against the wind
l Battery capacity is in
decline or there is a
fault with the battery
l Check tyres are properly
inflated
l Increase the amount of
pedaling independent of PAS
while riding on flat areas.
l Replace battery with the
new.
IMPORTANT!
We reserve the right to make modifications to E BIKE without prior notice.
4

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Urban-E-bike

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Urban E-bike bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Urban E-bike in de taal/talen: Engels als bijlage per email.

De handleiding is 0,24 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info