Using the Scanner Memories
Notes:
• Any frequency you program replaces the previous memory contents.
• If you enter a frequency you have already stored in a different
memory in Step 3, the scanner beeps and displays the channel where
you have previously stored the frequency. If you want to store the
frequency anyway, press E/PGM a second time in Step 3.
• To clear the contents of a memory, enter “0” in Step 3.
• Channels you program are automatically unlocked (see “Locking/
Unlocking Memories) and have Delay turned on (See “Setting
Channel Delay”).
Selecting a Memory
To select a single memory to monitor, press HOLD. The scanner turns on
the HOLD icon. Then, select a memory by pressing ▲ or ▼ to go to the
memory or input the memory number then press HOLD.
Scanning Memory Banks
To scan the memories you have programmed, press SCAN. The scanner
scans all unlocked programmed memories in enabled memory banks,
stopping on a memory when it detects a transmission. To turn on/off
memory banks while scanning, press the number button that corresponds
to the memory bank you want to enable or disable.
Locking/Unlocking Memories
You can lock memories so that they are not scanned, even if their bank is
turned on. Simply press L/O when the scanner stops on a transmission
on the frequency or manually select the memory, then press L/O. The
scanner turns on the L/O icon when it is set to a memory that is locked
out.
To unlock a memory, manually select the memory, then press L/O. The scanner
turns off the L/O icon and includes the memory when scanning its bank.
To unlock all memories of the bank, press and hold L/O for 2 seconds,
the scanner beeps twice and the L/O icon disappears.
