English
3
I UWATEC Aladin TEC 2G
• Avoid repeated heavy workload while at depth.
• Plan the dives to be shorter if they are made in cold water.
• After finishing the decompression or at the end of a no-stop dive, the final stage of the ascent should
be as slow as possible.
• You MUST be familiar with all signs and symptoms of decompression sickness before using Aladin
TEC 2G! Seek IMMEDIATE treatment for decompression sickness should any of these signs or symp-
toms occur after a dive! There is a direct correlation between the effectiveness of treatment and the
delay between the onset of symptoms and the treatment for decompression sickness.
• Only dive with Nitrox after you have been thoroughly instructed by a recognised institution.
Repetitive dives
• Do not start your next dive before your CNS O
2
% status has dropped below 40%.
• When diving with Nitrox, make sure your surface interval is long enough (just like diving with com-
pressed air). Plan for a minimum surface interval of two hours. Oxygen, too, needs sufficient time to
leave the body.
• Match gas mixture to the intended dive.
• Do not attempt a repetitive dive if the no-dive warning
is visible on the display.
• Plan a day without diving once a week.
• If you have to change computers, wait at least 48 hours before carrying out your next dive.
• Diving after a reset of the remaining saturation (reset, see page 47, or battery replacement, see
page 51) may lead you into
potentially
hazardous situations which could result in death or serious
injury. After a reset of the remaining saturation do not dive for at least 48 hours.
Altitude and diving
• Do not dive at altitudes higher than 4000m (13000ft).
• After a dive do not rise to altitudes that Aladin
TEC 2G
prohibits via the flashing altitude
range number (see page 29).
Flying after diving
• After diving, wait at least 24 hours prior to flying.
Aladin
TEC 2G
dive instrument is a personal protective equipment in compliance with the essential safety
requirements of the European Union directive 89/686/EEC. RINA SpA, Via Corsica 12, I-16128 Genoa,
notified body no. 0474, have certified the conformity with the European Standard EN 13319:2000.
EN13319:2000 Diving accessories - Depth gauges and combined depth and time measuring devices -
Functional and safety requirements, test methods. Any information on decompression obligation dis-
played by equipment covered by this standard is explicitly excluded from its scope.
Safety considerations
I
