1.2 Instructions in brief
1. Position the machine on a firm
base
2. Wash water tank, sieve support,
sieves and measuring spoon
3. Remove water tank and fill with
cold water. When replacing, you
must feel the tank slot into place
4. Plug in power connection and
switch on the machine at the
on/off switch (turn to ● t the
red operating display will light
up)
5. Place cup under steam nozzle,
open steam
valve on right and activate the
coffee supply switch (front left).
Then wait until water without air
emerges from the hot water
nozzle. Again activate the coffee
supply switch (fig. 5), and close
the steam valve switch. The
pump comes to a stop
6. To make coffee
- place sieve in sieve holder
(small sieve for 1 cup /
individual portions, large sieve
for 2 cups)
- add 1 level measuring spoon
per cup of ground coffee to
the sieve and press down
lightly with the tamper
7. Insert sieve support from below
(holding it on left) into the brew
ing unit, and then turn com-
pletely to the right. Place cup
under dispenser
8. Wait until the green control LED
lights up. Then turn right knob to
the right to . The pump is
now working. If the cup is full,
turn switch back again to .
The pump comes to a stop
9. After coffee has been dispensed,
remove the sieve holder and
knock out the coffee grounds
10.The machine should be regularly
cleaned and descaled
1.
3.
5.
7.
9.
6.
