Before putting the machine into operation for the first time, please read right
through the operating instructions.
Position the machine on a firm and stable base.
Do not try to carry the machine by the upper flanges!
First of all, wash all the accessories (sieve support, measuring spoon, sieve,
water tank) with lukewarm water and detergent, and then rinse them in
clean water.
The machine is fitted with an automated suction pump.
Place a cup under the brewing head, and turn the left knob to 1. You will
hear the noise of the pump. Just a few seconds later, water will start to flow
from the brewing head. Turn the knob again to as soon as the cup is full.
The pump will switch off.
Repeat this operation a few times before you start to make coffee, so as to
clean the pump and the water hoses.
If air is found in the hose system, the pump may be prevented from working
properly.
If no water comes out of the brewing head, place a cup under the steam
pipe. Turn the coffee quantity switch (on the front right of the machine) to the
right, open the steam valve and activate the coffee supply switch (front left).
Then wait until water without air emerges from the hot water nozzle.
Again activate the coffee supply switch, and close the steam valve switch.
The pump will stop.
Put the coffee quantity switch in the desired position 2.
The coffee machine is now ready to operate.
3. Commissioning
3.1 First commissioning
3.2 Setting up the machine
3.3 Preparing the machine
1
3.4 Filling / replenishing the water
tank
3.5 Air removal
2
It is essential that before doing anything else you
take out the water tank and fill it with cold water.
Otherwise your new coffee machine could be
damaged!
