Insert the plug into the socket with protective contact.
5.15 Making the electrical connection
Disconnect the unit from the mains power supply.
Undo the air exhaust tube.
If necessary, open the filter cover (for models with this cover)
Remove the grease filter. To prevent damage, do not bend the grease filter.
Disconnect the control panel harness and the lighting system harness.
Loosen the screws from the built-in furniture.
Slowly lower the unit.
Components inside the unit may have sharp edges.
Wear protective gloves.
1.
2.
3.
4.
5.
6.
7.
5.16 Unit Disassembly
WARNING - Risk of injury!
6. USE - FUNCTIONS
ATTENTION! LED lamps must not be covered with thermal insulation or other materials.
NOTE! Only turn on the LED lights while the hood is running. Do not turn on the lights to
illuminate the room. Do not touch the LED lamps within 30 minutes after use units.
Via the operating elements you set all the functions of your unit and receive information
about the operating status.
6.1 Control panel
Button for selecting minimum speed.
LED light On/Off button
Engine stop button.
Button for selecting average speed.
Button for selecting maximum speed.
6.2 Starting the unit
Press The unit starts in ventilation stage 1.
Note: The activated speed level will be indicated by means of the LED associated with
the button.
6.3 Adjusting the speeds
Press the desired speed level
exhaust pipe.
5.Seal the joints.
EN
20
