15
4. Installation with chassis with U-profile and frame
height of between 140 and 185 mm
The U-profile frame kit, 1, 2 or 3 spacer plate sets and the
set of screws are required to compensate for the U-profile
frame edge and the height.
5. Installation with chassis with L and U profiles with
frame height of less than 140 mm
With a chassis with a frame height (Y) of less than 140 mm a
flat frame kit must be fitted to compensate for the height.
In Germany, the flat frame kit installation must be
accepted by a vehicle expert.
Special accessory installation
Spacer plate kit
(Two 15 mm spacer plates)
For height compensation
max. 45 mm (3 plates) at each side
(e.g. installed behind axle)
Art. no. 60010-65500.
Set of screws
(for height compensation with
spacer plates, max. 45 mm)
eight DIN 933 screws
M10 x 105 8.8, galvanized,
Art. no. 60010-70000.
U-profile frame kit
(For frames with U-profile,
frame height approx. 185 mm)
Clamping plates and stoppers,
Art. no. 60010-09300.
Flat frame kit
For height compensation
for caravan/trailer with frame height
of less than 140 mm,
Art. no. 60010-09400.
In Germany, this installation
kit must be accepted by a
vehicle expert.
The Twin Mover is not approved for installation on
caravans/trailers with any other chassis! Any drilling
(exception: when using flat frame kit) or welding to the chassis
is not allowed. Under no circumstances remove any suspen-
sion components from the chassis.
Approval
Declaration of conformity:
The Truma Euro Mover Tandem/Twin Mover meets the basic
requirements of machinery directive 98/37/EC and is therefore
entitled to bear the CE symbol.
The Euro Mover Tandem has design approval, and a general
operating permit (ABE) has been issued for Germany. Accep-
tance by a vehicle expert is not required (except when in-
stalling the flat frame kit). The ABE must be kept in the vehicle.
When installing the Mover always observe the technical and
administrative rules and regulations of the country in which the
vehicle is to be registered for the first time.
Any modification to the unit, or the use of spare parts and
functionally-important accessories which are not original
Truma components, or failure to respect the installation and
operating instructions, will lead to the cancellation of the guar-
antee and to exclusion of claims for liability. in addition to this,
the operational approval for the device will be cancelled.
Tools and facilities required
To install the Mover you will need:
13 mm AF socket / wrench 13 mm AF combination spanner
17 mm AF socket / wrench 17 mm AF combination spanner
3 mm allen key
Torque wrench (automotive size)
Cable cutter/Crimping tool
Power drill, Screwdrivers, 25 mm hole cutter
Portable 2 tonne trolley jack and axle stands to suit
Appropriate lighting
Choice of location
We recommend to fit the Mover behind the rear axle. Under
special circumstances (for example lack of space) the Mover
can also be fitted in front of the front axle. Only the provided
original Truma mounting components and Truma accessories
must be used to attach the Mover.
The frame of the vehicle must be kept free of rust and heavy
soiling and without any damages to the suspension
components.
The caravan must be fitted with the same size and type of tyre
on each wheel; to ensure the wheel diameter is identical, we
recommend to install and set up the mover only with new
tyres, these are to be inflated to manufacturer’s specifications.
The Twin Mover weighs approximately 42 kg. Ensure the
pay load allowance of the caravan can accommodate this.
